Basic Operation
MODEINTLZ/DISPBBE8
DN g f UP 14B.C.9
Display Angle AdjustmentAdjusting Source Signal Levels
Movable display
If the difference in volume level between the CD
changer and FM radio is too great, adjust the FM
signal level as follows.
1Press and hold the INTLZ button for at least 3
The movable display may be adjusted to 3seconds.
different angles depending upon user preference.2Press the Preset 1 button to select the FM signal
level HI (High) or LO (Low) to make the signal
1Press the ANGLE 8 or 9 button to adjust thelevels between the FM band and CD changer
angle of the movable display.closer.
NOTES
" The display will close a half minute after the ignition3Press the INTLZ button to cancel the setting
key is turned to the OFF position.mode.
" The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the
Adjusting Volume/Bass/Treble/
power is turned back on.
CAUTIONBalance (Between Left and Right)/
Keep hands (or any other object) away from the displayFader (Between Front and Rear)
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a1Press the MODE (Audio Control) knob
malfunction. Do not touch.repeatedly to choose the desired mode.
Each press changes the modes as follows:
? VOL? BASS ?TREB
Subwoofer On and Off
FAD ?BAL ?
1Press and hold the INTLZ button for at least 3
seconds.NOTES
" If the MODE (Audio Control) knob is not rotated in 5
seconds after selecting the BASS, TREBLE,
2Press the Preset 4 button.
With each press, subwoofer is toggled On or Off.BALANCE, or FADER mode, the unit automatically
sets in the VOLUME mode.
" When the subwoofer, BBE mode is set to ON, the
3Press the INTLZ button to cancel the setting
level of the subwoofer, BBE can be adjusted.
mode.
NOTES2Rotate the MODE (Audio Control) knob until the
" Initial mode is "Subwoofer OFF."desired sound is obtained in each mode.
" Set to "Subwoofer OFF" unless the subwoofer is
used.NOTE
" When the subwoofer is turned on, the subwooferThe settings of the Bass and Treble will be individually
memorized for each source (FM, MW (LW) and CD
output level can be adjusted. For more details, refer
to the Adjusting Volume/Bass/Treble/Balance/Fader.changer) until the setting is changed. Depending on the
connected devices, some functions and display
4-ENindications do not work. |
ACEC
