Default Settings (SET UP)
3Use the Joystick to make the selection, then
press the ENT button.
ENT
DISP
MENU
SETBAND
RTN
V.OUT
DN
CLR
4 : 3 LETTERBOX
Select this when connected to a conventional 4:3
size (normal TV aspect ratio) monitor. There may
09
be black stripes visible at the top and bottom of
the screen. The width of these stripes will
depend upon the original aspect ratio of the
theatrical release of the movie.
Changing the TV screen settings
Use the procedure described below to set the
output screen according to the type of TV
monitor being used.
NOTE
When the settings are changed, the old settings are
overwritten. Make a note of the current settings before4 : 3 PAN-SCAN
making changes. The settings are not cleared even
Select this when connected to a conventional 4:3
when the vehicleOs battery is disconnected.
size monitor. The picture will fill the entire TV
screen. However, due to the mismatch in aspect
1In the stop mode, press the SET button for at
ratio, parts of the movie at the extreme left and
least 2 seconds.
right sides will not be visible.
The default setting menu appears.
NOTE16 : 9 WIDE
This operation cannot be performed in the PRE-STOP
mode.Select this when connected to a wide screen TV.
This is selected upon shipment from the factory.
2Use the Joystick to select OTV SCREEN�, then
press the ENT button.
22-EN |
ACEC
