The water is not pumped There is a fault in the
out of the washing ?Water Stop?.
machine.An acoustic signal sounds, the
An acoustic signal sounds and notice ?Overdosing? or ?FA?
the notice ?FP? appears in the appears in the display and the
display.pump operates.
Switch off the washing machine This fault can be triggered by:
and pull out the mains plug.1.Excess foaming;
Check whether:
2.A leak in the washing machine.
? The drain hose is kinked (see
In this case the pump is switched
?Installation/Connect the on automatically in order to
water drain hose?);
pump out the water.
? The pump or the filter is
Switch the washing machine off,
blocked (see ?Removing the pull out the mains plug and turn
Filter?).
the water tap off. Tilt the
IMPORTANT: Before emptying appliance forwards carefully to
ensure that the water has
allow the collected water to
cooled down.drain out of the appliance base.
? The water in the drain hose is
Then:
frozen.
1.Reinsert the mains plug in the
Reconnect the appliance to the socket.
electrical socket.2.Turn the water tap on [if water
Switch the washing machine on immediately flows into the
again, select a programme and appliance again, without the
start the appliance. To rinse the appliance being started, there
laundry, we recommend a short is a fault. Turn the tap off and
notify After Sales Service, see
programme without the
addition of detergent.?After Sales Service?).
3.Switch the washing machine
If the fault occurs again, please on again, select the desired
contact After Sales Service (see programme and start the
?After Sales Service?).appliance.
There is a fault in an If the fault occurs again, please
contact After Sales Service (see
electrical component.
An acoustic signal sounds and a ?After Sales Service?).
notice from ?F4? to ?F16?
appears in the display.
? Press the ?Reset? button. The
programme will start again.
? If the fault occurs again, please
contact After Sales Service (see
?After Sales Service?).
39 |