4gb66021.fm Page 5 Wednesday, June 23, 2004 10:41 AM
ELECTRICAL CONNECTION
Warning: This appliance must be earthed. Fit an all-pole On/Off switch between the appliance
Electrical installation must comply with all relevant and the power supply with minimum contact
local and national regulations. Make sure that the separation of 3 mm.
voltage supply is the same as the voltage shown on the If necessary, the electrical power cable must be
rating plate positioned on the lower part of the front replaced exclusively with a power cable having
of the oven.identical characteristics to the original supplied by the
This appliance must be connected to an a. c. single manufacturer. This operation must be performed by
phase 230V, 50Hz electricity supply.the After Sales Service or a qualified electrician.
The total rated load is 4.120 kW, connect the
appliance accordingly.
BEFORE USING THE OVEN
For best use of this oven read the instructions for use Remove the accessories from the oven and heat it at
carefully and keep them in a safe place. the maximum temperature for about 1 hour to
Remove the cardboard and polystyrene protection remove the odour and fumes from the insulating
from inside the oven. material and the protective greases.
Clean the inside of the oven with non abrasive soap The window should be kept open during this
and warm water. operation.
SAFEGUARDING THE ENVIRONMENT
1. Packing
The packaging material is 100% recyclable, as
confirmed by the recycling symbol .
2. Oven
The oven has been manufactured with recyclable or
reusable material. Dispose of it following the local
regulations for waste disposal. If the oven is to be
scrapped, cut off the power cable.
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
This oven is designed solely for use as a home Fruit juice drippings from the baking tray may leave
appliance for cooking food. Any other use is forbidden. permanent stains. We recommend the oven be
The manufacturer assumes no responsibility for cleaned before reusing it.
damage caused by improper or incorrect use. Never drag pots and pans across the bottom of the
Any repairs or servicing must be carried out oven to prevent the coating from being scratched.
exclusively by a qualified technician. Residual condensation after cooking could damage the
Never expose the oven to atmospheric agents.oven and surrounding kitchen units in time.
Do not put heavy objects on the doors because they We recommend that you:
could damage the oven cavities and hinges. Do not - set the lowest temperature;
cling to the doors.- cover food;
Never hang anything heavy on the oven doors handles.- remove food from the oven;
Do not cover the bottom of the oven with - dry the wet parts when the oven is cool.
aluminium foil or other objects. The front panel and the handle of the oven doors
The oven doors must close properly. The door seals warm up when the appliance is switched on for a long
must be kept clean.time at high temperatures.
Do not pour water directly into the inside of a hot Never touch the oven with any wet part of the body
oven. The enamel coating could be damaged.and do not operate it with bare feet.
Do not pull the appliance or the power supply cable to
disconnect them from the electrical supply. |
ACEC
