4Gb33008.fm5 Page 7 Wednesday, August 22, 2001 5:36 PM
After-sales service
Before contacting After-Sales Specify:
Service:? The nature of the problem.
1. See if you can solve the problem ? The model.
yourself with the help of ? The service code (number
theTroubleshooting guide?).below the word SERVICE on the
2. Switch off the hood for a few rating plate inside the hood
minutes and re-start it to see if behind the grease filter).
the problem has cleared itself.? Your full address.
? Your telephone number and
3. If the malfunction persists, call area code.
After-Sales Service.
Installation
When installing the hood, the 2. Some models are fitted with Electrical connection
minimum distances from the a plastic deflector that
cooktop must be respected, closes off the rear outlet. If Before connecting the hood,
make sure the voltage
and the numerical sequence fitted, remove it.
indicated on the rating plate
and additional instructions 3. Fit the collar in the rear corresponds to the voltage in
must be followed exactly as
outlet.your home.
indicated on the Installation
sheet.4. Put the cover (if fitted) in The plate is located inside
the upper outlet.the hood behind the grille.
External Exhaust ModeFor GB this appliance is
Warning!If the hood has a
(A - see also installation carbon filter, this should be supplied without a plug and is
removed.intended for direct connection
sheet)to fixed wiring in accordance
Check that the switch inside the
Cooking fumes and vapours are with national wiring
conveyed outside through a hood (if fitted) is in regulations. An all-pole
position?A? Extractor; if not,
duct connected to the hood by disconnection switch with a
means of a collar.set it to this position.minimum contact separation
The outlet duct diameter of 3 mm must be included in
must be the same as that of the fixed wiring in an easily
Air Circulation Mode
the collar.accessible position.
If a flue-damper is to be (F - see also installation The Manufacturer shall not
installed, check that it can sheet)be liable for any damage or
open and close freely when The air is filtered by a carbon problem arising from the
installation of the exhaust filter and recycled into the failure to comply with the
duct is complete.surrounding atmosphere. The above-mentioned
instructions.
The hood can be supplied filtered air is released towards
with one (upper) or two the kitchen ceiling.
(upper and rear) exhaust Warning!If the hood does
outlet holes.not have a carbon filter,
The hood is usually set up order one and fit it before
for using the upper exhaust use.
outlet.Check that the switch inside the
1. The collar must be seated in hood (if fitted) is in position
the upper exhaust outlet.?F? Filter; if not, set it to this
Use the rear exhaust outlet position.
(where present).
If the plug is provided, close off
1. Where fitted, remove the
cover closing off the rear the upper exhaust hole.
outlet and collar.
7 |
ACEC
