Installation
Cooktopof the cooktop to the
Y The cooktop must be setside of the column unit.
into a worktop betweenY Cut an opening in the
20 mm and 50 mmworktop of the dimensions
thick. shown in the Product
There must be nothingDescription Sheet supplied
between the cooktopseparately.
and the oven (crossY If not already present, fit
rails, brackets, etc.).the supplied seal to the
Y If the cooktop is to becooktop flange after
installed next to acleaning the contact area
column unit, leave aas shown in the figure.
distance of at least
100mm from the edge
Cooktop with electric
hotplates
Y If the worktop is made of
wood, fit the supplied clips.
1.Position the 4 spring clips
(B) and fit them in their
locations on the underside
of the cooktop.
2.Fit the cooktop into the
worktop.
Y If the worktop is made
of marble, plastic,
ceramics, natural stone,
etc., the cooktop must be
secured with brackets (C)
code 4819 310 18528 (to be
requested from After Sales
Service).
1.Position the brackets over
the holes and secure them
with the supplied screws.
2.Fit the cooktop into the
worktop. |
ACEC
