94017-gb.fm5 Page 20 Wednesday, September 26, 2001 6:15 PM
MAINTENANCE AND CLEANING
Before cleaning or carrying out maintenance,
press the ON/OFF button.
1. Clean the appliance exterior with a neutral
detergent. Do not use abrasive detergents.
2. Regularly wipe the door seal and inside of the door
with a damp cloth to remove any food residues.
BA
If the spray nozzles become clogged with food
residues, clean the spray arms as follows:
Upper spray arm:
? Slacken the fixing nut by turning it counter-
clockwise A and detach the spray arm by pulling it
down B.
? Rinse the nozzles.
? Remount the spray arm by aligning it with the
rotary mounting and insert it.
? Tighten the fixing nut by turning it clockwise.
Make sure the nut is fully tightened (it should click).
Make sure the spray arm rotates freely.
B
Lower spray arm:
? Press the two levers inwards which fix the spray
A
arm A and detach by pullinBg it up.
? Rinse the nozzles.
? Remount the spray arm by aligning it with the rotor
pin and insert it.
? Push the spray arm down until it is fixed in place.
? Make sure the two levers are correctly inserted
(they should click).
Make sure the spray arm rotates freely.
A
B
Cleaning the filters
1. Fully unscrew the wide-mesh central filter by
turning it counter-clockwise and eA. xtract it
2. Fully unscrew the cylindrical filter and extract it
from the wide-mesh centraBl filte (pay drue
attention to the holes in the bottom of the filter).
3. Remove the fine-mesh filter C.
C
4. Clean all the components.
5. Reassemble:
Insert the cylindrical filter in the wide-mesh central
filter. Fit the fine-mesh filter and screw down the
filter unit by turning it clockwise. The filter unit
must be correctly assembled to ensure good
washing results.
20 |
ACEC
