How to use the dishwasherUpper and lower rack
1. After loading the dishwasher, cl6.osOnce the te he Start indicator lamp haCrocs kery holders:Lower rack
door properly and open the water switched off press the On/Off buttoDown: cups ann to d long-stemmed glasses.
supply tap.switch the dishwasher o All the ff.Up: plates.
B
2. Press the On/Off button to switch theindica tor lamps switch off.
dishwasher onOn.e o f the programme 7. Open the door (warning: beware of hot A
indicator lamps will switch on.steam). Unload the lower rack before
the upper one. Close the water tap.
3. Select the desired programme by
Upper rack
pressing the correspondingThe button.
corresponding indicator lamp lights
up. If required, select options (if supplied).
C
?Vario Organize? multri-purpose
4. Press the Start button to start the
support:
selected programmThe Start e.
To be used, for example, for long-
indicator lamp will li Once seght up.t,
handled utens(ailrras nge knives
the programmed data cannot be Plate holders:
with the blade facing downwards),
altered by pressing the programme May be lowered to increase
cups and glasses.
selector buttons.available spaceA). (
May be used in three different
Note: Once the Start button has been May be removed to increase available
positions (see ?Dialshsowa sher
space (B). To remove: pull the handle
pressed, the dishwasher memorises the
loading instruc? tonio Pagns e 4).
up.
last programme selected. This 1. Upon the left-hand side of the rack.
information remains in the memory even 2. Upside-down, towards the centre of B
during interruption of the power supply.the rack.
A
To change the selected 3. Upside-down, towards the left side.
programme, press the Start
button for about 5 s,e ucondntil s
the Start indicator lamp
switches off. Select a new
programme using the
programme selector knob and
Cutlery basket:
press the Start button.
The cutlery basket can be removed to
Note: If the dishwasher is switched off
increaseC () available space.
during a wash programme, when
switched on again it will resumeRa thck he waeshigh t adjustment:Glass holder:C
cycle from where it was interrupte(The dishd.washer is delivered with the upper
Only open the dishwasher dorack in or if the top position).
strictly necessary during Tha wae rash ck height can also be changed
cycle and exercise maximum when loaded.
caution. Danger of scalding fromTo l ower: pull out two the side
steam.handles and gently lower the rack.
To raise: pull up the two side handles
5. To indicate the end of the programme,
until the rack clicks into place.
the Start indicator lamp switches off
The rack must be level on both
and the End indicator lamp (if fitted)
sides.
switches on (for about 30 mi. n.)
Please read the user instructions carefully. |
ACEC
