Before using the dishwasher, read the user instructions!
GB
GSFH 1988Quick Reference Guide
Wash cycle
Programme selector knob
Programme
Pre-RinseWashingDrying
end
Options
3)
On / Off buttonTime and failure display
Indicates in hours the time remaining until the start
of the wash cycle. Switches off at programme start
and indicates the remaining time in hours and
minutes.
Start button?F....? Information for the After-Sales Service
Switches ?on? when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.?Delayed start? buttons
The wash cycle can be programmed to start after 1 -
24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button.
IndicatorsThe dishwasher will start at the set time.
Add regeneration salt
Only add regeneration salt immediately before ?Half load? button
starting a wash programme.
This function can be used with any programme. The
indicator lamp switches on. The wash cycle is
Add rinse aid
activated for the upper or lower rack only.
When washing without the top rack, press the ?Half
No water
Load? button (LED alight).
Check that the appliance fills with water.
2)
Programme chartDetergentConsumption3)
ProgrammesLoading instructionsABLitreskWhMinutes
1)Lightly, normally or heavily soiled
INTELLIGENT40-70°CXX7.0-17.0 0.99-1.58 60-146
crockery, including pots and pans.
Pre-RinsecoldCrockery to be washed later.--4.00.0314
Glass40°CLight soiling, for example glasses and cups.X-10.00.8055
Lightly soiled crockery with no dried-on
Rapid 30 min40°Cfood.X-10.00.6530
4) 5)Normally or heavily soiled crockery, with
Hygiene +additional antibacterial action.XX13.01.50115
1)Reference programme for energy label EN 502424)The bacteria removal efficiency has been tested by the Institut
(Liter = 13.0, kWh = 1.05, Min. = 120);Pasteur de Lille (France), based on the NF EN 13697 standard of
2)Refer to ?User instructions?;November 2001.
3)Program data obtained in conformity with European standard 5)Programme interruption (e.g. the door being opened) may
EN 50242. Values may vary in relation to usage, e.g.: different loads, compromise the result of the antibacterial rinse.
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
[email protected]?.
5019 496 90397
(We reserve the right to make technical modifications)
BK/I/B/GB
ACEC
