Before using the dishwasher, read the user instructions!
GB
GSU 5536Quick Reference Guide
Programme cycle
Programme selector knob
Pre-RinseWashingDryingEnd
Options
?Delayed start? button
The wash cycle can be programmed to start after
3-6-9 hours. Then press the Start button.
On / Off button
The wash programme will start at the set time
Start button?Half load? button
Switches ?on? when the dishwasher is The half load cycle can be used for the upper and
operating. Flashes when a fault occurs. lower rack. Select the required programme then
Switches off at the end of the programme.press the ?Half Load? button. The light comes on
and goes off at the end of the programme.
The ?Half Load? function can be used with
programmes marked with an *.
Indicators4)
Antibacterial rinse
This function adds an antibacterial rinse at the end
Add regeneration saltof the wash cycle, thereby guaranteeing a perfectly
Only add regeneration salt immediately clean and sanitized load. The lamp will light up
before starting a wash programme.when the function is activated. If the temperature is
not maintained during the antibacterial cycle (e.g. if
Add rinse aidthe door is opened and remains open for a long
time), the lamp will start blinking to indicate that
sanitation is not guaranteed.
2)
Programme chartDetergentConsumption3)
ProgrammesLoading instructionsABLitreskWh Minutes
Pre-RinsecoldCrockery to be washed later.--5.00.0210
Lightly soiled crockery with no
Rapid 30 min40°CX-13.0 0.7030
dried-on food.
1) 5) (*)
Standard50°CNormally soiled crockery.XX16.0 1.05140
5) (*)
Normal65°CNormally or heavily soiled crockery.XX16.0 1.65100
Recommended programme for
5)
Intensive70°Cheavily soiled crockery, especially XX17.0 1.90135
suitable for pans and saucepans.
1)Reference programme for energy label EN 502424)The bacteria removal efficiency has been tested by
2)Refer to ?User instructions?;the Institut Pasteur de Lille (France), based on the NF
3)Program data obtained in conformity with European EN 13697 standard of November 2001.
standard EN 50242. Values may vary in relation to 5)These programmes can be used with the Antibacterial
usage, e.g.: different loads, water temperatures - rinse option.
above or below 15°C - as well as water hardness and
power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
[email protected]?.
5019 496 90412
(We reserve the right to make technical modifications)
ACEC
