Turn On MessageDSC programming_
This unit offers you the possibility to enterThe car radio has been equipped with DSCLOUDNESSLoudness boosts the bass
a turn on message of up to 40 characters.(Direct Software Control) to allow you tofrequencies at low volume.
The message will briefly appear in the dis-customize certain programmable, basicLOUD 1 - Low boost
play each time you turn the unit on.settings to suit your personal needs andLOUD 6 - Max. boost
Proceed as follows:preferences and then store them.
The basic settings for this car radio were
Select the DSC mode.BAS CENTBass Center Frequency Ad-
made at the factory.
justment.
Press DSC.
In the following you can find an overview ofAdjusts the mid-range fre-
Press A/V to select TOM.these settings, so that you can always re-quency to the specific
Press <c to turn the message off.set to them if desired.equipment in the vehicle
Press >> two times to select the editIf you wish to alter any of the programming,(50 or 100 Hz)
mode.l press DSC.
If there is no TOM programmed, dash-?MENUv/A? will temporarily appear in theSTA NAMEAllows you to name up to
es ?_?will appear in the display.display.30 radio stations based on
The cursor will flash at the current po-Use the V/A buttons of the rocker switchtheir frequency.
sition. Press cc / >> to move the cur-to select the function you wish to change.
sor.The display will show you the setting youSENS LOAdjusts seek tuning
Press A/V to select a character. Ifhave selected. Press the cc >> buttons ofsensitivity.?LO? stands for
you want to enter a blank, select thethe rocker switch to change the settings andlocal reception.?DX? stands
exit the current mode. Confirm the setting
dash ?_?.for distant reception.
you have selected by pressing the DSCSelect ?Lo? if you want to
Press DSC to store the message.
button.receive strong stations in
Press DSC again to quit the DSC
the local area, select ?DX? if
mode.
you want to tune into weak-
If you want to change the message, select
er stations which are further
TOM in the DSC mode and overwrite it in
away.
the edit mode. If you want to change just a
few of the letters, press cc / >> to move
the cursor to the corresponding position and
change that character only.A/V Select function
cc X. Adjust/recall setting
19 |
ACEC
