Condensed instructions
1 Disengaging the fold-down control2 ONSwitching the unit on/off using the
panelSwitching on the unitKeyCard
Disengage the control panel to insertInsert the KeyCard and press ON brief-Insert/remove the KeyCard to switch
or remove the KeyCard and CD.ly.the unit on and off.
To disengage the control panel, pressThe unit is switched on in the last op-Refer also to the description of the
knob 1: the control panel folds down.erating mode selected and with theKeyCard anti-theft system @ in the
The control panel cannot be removed,previously selected volume.condensed instructions.
nor should it be used a shelf.
To re-engage the control panel, push itSwitching on/off by the ignition
back into its original position (Arrow 3).The unit may be connected up such
that it is switched on and off by the ve-
hicle ignition.
When the ignition is switched off, a
Switching off the unitdouble beep reminds you to remove
Press ON for approx. 1 second.the KeyCard before leaving the vehi-
2
cle.
The display can be adjusted for the de-
1Switching on whilst the ignition is
sired viewing angle in order to improve
3
legibility. Refer to Improving the legi-off
bility of the display if necessary.With the ignition off (and the KeyCard
For safety reasons, the controlinserted), proceed as follows to oper-
ate the unit:
panel must always be engaged Switching the sound on/off
whilst the vehicle is moving. Press ON briefly. MUTE appears onPress ON when the double beep
When leaving the vehicle, open thethe display when the sound is switchedsounds.
control panel and remove the Key-off.The unit is switched on.
Card in order to prevent theft.To switch the sound back on again,The unit switches itself off automatical-
turn the volume knob 3.ly after an hours use in order to pre-
vent the vehicle battery from running
down.
4 |
ACEC
