ONE CHANNEL DOES One channel does not ? One of the Phono cartridge or ? Connect it
NOT WORK work the RCA amplifier connectors is not
connected
? One of the internal wires is ? Contact your local dealer
disconnected
SPEAKER HUMMING The speakers hum, once ? Ground or No -Ground the thin ? Find the best solution
PROBLEMS your amplifier is selected wire comes out the DIN connector of the
on Phono input. amplifier cables
? Your Amplifier needs to be ?
grounded
? The internal ground wire is ? Contact your local dealer
disconnected
The speakers, once your ? Your Amplifier needs to be ?
amplifier is selected on grounded and shielded
Phono input, h um or get
Radio stations signals
ANTI SKATE The tone arm tends to be ? ? We suggest not to use the
attracted to the center of Anti-Skating system on such tone arm
the record during playing but eventually use the plastic wire
weighted on one side to wrap around
the horizontal cylinder with 2 grooves,
present on the arm lift board, after
being tied on the small screw inserted
on the olive shaped top of the arm
wand.
EXTERNAL ARM CABLE Your tone arm male DIN ? ? Ask you local dealer to have
FITTING connector of cable the proper external amplifier cable with
amplifier can not reach STRAIGHT DIN connector you need
the female DIN connector
in the tonearm shaft
Your tone arm male DIN ? ? Ask you local dealer to have
connector of cable the proper external amplifier cable with
amplifier get i n touch with 90° BENT DIN connector
the turntable shelf once
installed into the female
DIN connector in the
tonearm shaft
POORED OIL FROM THE Some oil stains are found ? The arm lift cylinder is open on ? Clean the stains from the
LIFT CYLINDER into the tone arm box or its bottom and it can drop some exceed turntable with extreme care using
on the turntable board oil when it is new alcohol and a super soft 100% cotton
once the arm is installed cloth
Troubleshooting 8
B-7 TITANIUM Bearing Tonearm
F.A.Q.
Adjustment
B-7 Titanium Bearing Tone-Arm |
ACEC
