BM 2610908996 6-04 6/21/04 4:47 PM Page 10
YTo position switch on the left, line up the4. Turn the motor clockwise until it stops.
baseOs arrow with arrow on the motor5. Push the motor into the base as far as it
housing that is below the switch.will go.
3. Slide motor into base until resistance in6. Fasten the base clamp lever.
felt. (The baseOs guide pin is now engaged
into slot on motor.)
INSTALLING TEMPLET GUIDE ADAPTER
Place templet guide adapter over the holes inFIG. 9
the center of the sub-base, and align the two
threaded holes in the bottom of adapter withTEMPLET GUIDE
ADAPTER
the countersunk holes in sub-base. Fasten
adapter with the screws provided. Note that
the adapter is reversible, so the release lever
Fig. 9
MOUNTING SCREWS
CHIP DEFLECTOR FIG. 10
Always wear eye
protection. The chip!WARNING
deflector is not intended as a safety
guard.
The chip deflectors help keep dust and chips
out of your face, it will not stop objects larger
than dust thrown from the bit.
To remove chip shield from bases, press
inward on tabs until it releases from base and
remove. To attach, place deflector into
Fig. 10
sides of deflector while pushing until it snaps
into place. The plunge baseOs chip shield can
also be flipped out.
-10-
210IN50403020100MM |
ACEC
