Strike long arm of wrench sharplyFIG. 3
counterclockwise, remove wrench and
unthread chuck from spindle.
INSTALLING CHUCK
Always keep the spindle threads, the threads
of the chuck and securing screw free of
debris. To install a chuck, reverse Oremoving
the chuck� procedure.
RELEASING AND INSERTING BATTERY PACK
Release battery pack from tool by pressingpack. To insert battery, align battery and slide
on both sides of the battery release tabs andbattery pack into tool until it locks into
pull downwards. Before inserting batteryposition. Do not force.
pack, remove protective cap from battery
1 HOUR CHARGER
Plug charger cord into your standard powermean the battery pack is too hot or too cold.
outlet. Before inserting battery pack, removeThe purpose of the light is to indicate that the
protective cap, then insert battery pack intobattery pack is fast-charging. It does not
Fig. 4
indicate the exact point of full charge. The
The chargerOs green indicator will begin tolight will stop blinking in less time if the
OBLINK�. This indicates that the battery isbattery pack was not completely discharged.
receiving a fast charge. Fast-charging will
automatically stop when the battery pack isWhen the battery pack is fully charged,
unplug the charger (unless you're charging
fully charged.another battery pack) and slip the battery
When the indicator light stops OBLINKING�pack back into the tool handle.
and becomes a steady green light
To prevent fire or injury when batteries are
charging is complete.not in tool or charger, always place protective
When you begin the charging process of thecap onto end of battery pack.
battery pack, a steady green light could also
FIG. 4
BATTERY
PACK
CHARGER
PROTECTIVE
CAP
INDICATOR
LIGHT
-9- |
ACEC
