The blade assembly may be easilyquick release handle of the blade
removed, by inverting the blender,assembly and turn clockwise to the
pressing down on the quick releasestop. The blade assembly is then back
handle, turning it counterclockwise untilin place.
it stops, as shown in figure 10a, and
then lifting up, see figure 10b.3. If you have not already done so, remove
the motor drive cover and place the
blender on the mono drive. Turn
counterclockwise to lock the blender
in place, see figure 12a.
Placing Blender into Operation
Make sure that the switch is in the Off
position, ?O/Off.? Unwind the electrical cord
to the necessary length and plug it into wall
outlet. The blender is now ready for
Figure 10.operation.
Wash the blade assembly under
running water. Do not place the blade
assembly in the dishwasher or allow it
to stand in water. This will tend to wash
out the lubricant. After cleaning, rinse
thoroughly and dry before using.
Figure 12.
-Normally when blending, the blender jar
should be filled with the entire amount of
material to be blended, if possible, before
switching the appliance on. The cover and
cover closure should always be in place after
filling the blender jar, and before switching
the power unit to On. Any subsequent
additions to the blended material should be
made through the cover opening, see figure
Figure 11.13. For solids and/or granular material,
remove the cover closure/funnel to add the
2. To assemble or reassemble bladematerial, as shown in figure 13a. For liquids,
assembly into the blender, insert thethe closure/funnel may be left in place and
blade assembly into the blender jar asthe liquids added by pouring them into the
shown in figure 11, press down on theclosure/funnel, see figure 13b.
16 |
ACEC
