Troubleshooting
The power doesnOt come on.Sound is distorted.
M Is the guitar connected correctly to the INPUT M Are the TONE knob positioned correctly?
A (MONO) jack?? Sounds may become distorted with the knob at
? Check the connections again (p. 4�p. 7).certain settings. Turn down this knob, or turn
* When running off batteries, the unit wonOt switchdown the E.LEVEL knob to appropriate level. If
on unless thereOs something plugged into thein spite of these measures the sound is still
INPUT jack. This helps conserve the batteries.distorted, lower the output level of the device
connected to the INPUT jacks, or set the Output
M Is the plug connected to the INPUT B jack?Mode to +4 dB (p. 30).
? When using battery power, connect the plug to
the INPUT A (MONO) jack.Pressing the MEMORY/TAP pedal
does not call up the intended
M Have the batteries run down?memory.
? Replace with fresh batteries (p. 3).
M Is the proper Pedal mode set for your current
M Is the specified AC adaptor (PSA-series sold application?
separately) connected correctly?? The MEMORY/TAP pedal (or the MEMORY/
? Check the connections again (p. 4�p. 7).TAP pedal when pressed simultaneously with
ON/OFF pedal) functions differently according
There is no sound.to the Pedal mode settings. Use the most
M Is the other equipment connected correctly?appropriate setting for your particular
application (p. 29).
? Check the connections again (p. 4�p. 7).
M Is the volume turned down on the connected M Is the MEMORY/TAP pedal set to the TAP
function?
guitar/bass amp, effects processor, or other
device?? If the MEMORY/TAP pedal is set to TAP
(MEMORY/TAP pedal has been pressed for
? Check the settings on the connected equipment two seconds), the pedal functions as a Tap
(p. 4�p. 7).
Input pedal. To switch memories, either change
M Is the Output Mode set correctly?the pedal to the MEMORY switching function
? Set the Output Mode to match the connected by holding down the MEMORY/TAP pedal for
equipment (p. 30).two seconds, or use an external pedal
(p. 14�p. 15).
M Is the Output Mode set to A: DIR / B: EFX?
? No sound is output from the OUTPUT B jack The volume level of the
when the ON/ OFF pedal is set to OFF. Set the instrument connected to INPUT
Output Mode to Stereo output (out 1 or out 3) jack is too low.
(p. 30).M Could you be using a connection cable that
M Is the effect level (E. LEVEL knob) set to minimum?contains a resistor?
? Operate the E.LEVEL knob to adjust the effect ? Use a connection cable that does not contain a
level (p. 16).resistor.
35 |
ACEC
