Chapter 8 Creating and Performing Songs ([SONG])
3. Press [ENTER] to determine the pattern  When Using Realtime Recording
to be recorded.
The sounds are recorded as the patterns are
The measure numbers advance automatically.
switched with the pads.
The asterisk (*) indicates that the pattern
*When recording over a song that has already been
displayed has not been confirmed. If you press
recorded, the newly recorded data overwrites the
[EXIT] at this point, the pattern that has already
previously recorded data, which is discarded.
been set appears in the display. If no pattern has
Make sure you have pressed [SONG] to switch to
been confirmed, O- - - -� is displayed. Once you
confirm the pattern, the asterisk disappears.Song mode.
1. Hold down STEP REC [] and press
4. Press [] [] to change the step to
START [].
be recorded.
fig.08-02d-1
5. Repeat Steps 2�4 as needed to record the
data for the song.
6. To stop recording, press STOP [].
The STEP REC [] goes out.
*Note that pressing START [] during Step 2. Turn the VALUE dial to select the style,
Recording (while STEP REC [] is lit) switches the and press a pattern pad to specify the
DR-3 to Realtime Recording.first pattern to be recorded.
Recording begins from the pattern specified.
Erasing Previously Recorded Sounds
The Song Recording screen appears.
As You Continue Recordingfig.08-05d
Song No.Style No.
You can use the following procedure to delete the
displayed pattern.
1. Press [] [] to display the pattern to
be deleted.MeasurePattern Name
2. Hold down STEP REC [] and press
3. Perform by switching the patterns with
[ENTER].
the pattern pads.
The pattern is deleted, and the subsequent
Perform exactly as in Style Manual mode (p. 43).
patterns are shifted forward.
The ON/OFF status of the VARIATION Ch
ap
[PTN], [KIT] and [MUTE] (p. 45) is also
t
recorded.er
8
You can also change styles by turning the
VALUE dial.
*If you switch the style during its performance, a O �
mark appears in front of the style name which will be
played next. The style switches after the currently
playing pattern ends, and the O � mark disappears.
*The ON/OFF status of the VARIATION buttons and
fill-ins can be recorded only in a unit of pattern.
4. When you press [ENDING/STOP], the
ending is played, and then both the
performance and the recording stop.
If you want to stop the recording
immediately, press STOP [].
77 |
ACEC
