Chapter 8 Other Features
Setting OExpression Pedal Hold�Setting the Knob Functions
(Knob Mode)
This setting determines whether or not the Pedal AssignOs (p.
47) operational status is carried over to the next patch when
patches are switched.This sets the way the values of settings are changed when the
control knobs are turned.
* Expression Pedal Hold does not function if the Assign Source
mode is set to Toggle (whereby the value is toggled between
1. Press [UTILITY], then press PARAMETER []
Min and Max each time the pedal is pressed).[] so that OKnob Mode� is displayed.
fig.08-06
1. Press [UTILITY], then press PARAMETER []
[] so that OEXP Pdl Hold� is displayed.
fig.08-05
2. Rotate the PATCH/VALUE dial to set the Knob mode.
Immediate:
2. Rotate the PATCH/VALUE dial to set Expression Pedal Turning the knobs immediately changes the values.
Hold.
Current Setting:
On: The Pedal Assign status is carried over.
Values begin to change only once the knob position
(Example)reaches the values set in the patch.
If a patch is switched while the volume is being
controlled with the expression pedal, the volume of the
3. Press [EXIT] to return to the Play screen.
subsequent patch will take on the value determined by
the current pedal position (angle).
If the patch switched to has the expression pedal
controlling the wah effect, then the volume assumes the
value set in the patch, and the patchOs wah effect is given
the value derived from the current pedal position
(angle).
Off: The Pedal Assign status is not carried over.
(Example)
If a patch is switched while the volume is being
controlled with an expression pedal, the volume of the
subsequent patch is set to the value set in that patch.
If the expression pedal is operated, and that information
is transmitted to the GT-6, the volume will change in
accord with the pedalOs movement.
3. Press [EXIT] to return to the Play screen.
62 |
ACEC
