" Do not place carbonated or fizzy drinks in the" There are working parts in this product whichFurthermore, it is necessary that the niche is provid
freezer as it creates pressure on the container,heat up. Always ensure that there is adequatewith a conduct of ventilation having the following
which may cause it to explode, resulting inventilation as a failure to do this will result indimensions:
damage to the appliance. Do not use acomponent failure and possible food loss. Seedepth 50 mm
mechanical device or any artificial means toinstallation instructions.width 540 mm
speed up the thawing process other than those" Parts which heat up should not be exposed.
recommended by the manufacturer. Never useWherever possible the back of the product should
metal objects for cleaning your appliance as it
be against a wall.
may get damaged.
InstallationEnvironment Protection
" During normal operation, the condenser andThis appliance does not contain gasses which
compressor at the back of the appliance heat upcould damage the ozone layer, in either its
considerably. For safety reasons, minimumFit the appliance in the niche by making sure that it
refrigerant circuit or insulation materials.The
ventilation must be as shown in the instructions.appliance shall not be discarded together withstands against the interior surface of the unit on the
Attention: keep ventilation openings clear ofthe urban refuse and rubbish. Avoid damagingside where the door hinges of the appliances are
fitted. Insert the appliance until the upper strip butts
obstruction.the cooling unit, especially at the rear near the
heat exchanger. Information on your localup against the unit (1) and make sure that the lower
" Care must be taken to ensure that the appliance
disposal sites may be obtained from municipalhinge is in line with the surface of the unit (2).
does not stand on the electrical supply cable.
authorities.The materials used on this appliance
Important: if the supply cord is damaged, it mustmarked by the symbol are recyclable.
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
" If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
Fasten the appliance with 4 screws provided in the
wait at least two hours before connecting the
appliance to allow the oil to flow back in thekit included with the appliance.
(I = 3,5 x 13) (P = 3,5 x 22)
compressor.
CONTENTS
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Apply the sealing strip pushing it between the
Use - Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration . . . . . . . . . . . . . . . .5
refrigerator and the adjacent cabinet.
Use - Freezing fresh food - Storage of frozen food - Thawing - Ice-cube production . . . . . . . . . . . . . . . . . . . . .6
Use - Movable shelves - Positioning the door shelves - Removable drawer - Freezing calendar . . . . . . . . . . . .7
Hints - Hints for refrigeration - Hints for freezing - Hints for storage of frozen food . . . . . . . . . . . . . . . . . . . . . . . .8
Maintenance - Periods of no operation - Periodic cleaning - Interior light - Defrosting . . . . . . . . . . . . . . . . .9
Customer service and spare parts - Technical information - . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
Installation - Location - Electrical connection - Door Reversibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Installation - Building-in instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Apply covers (C-D) on joint cover lugs and into hinge
holes.
Snap vent grille (B) and hinge cover (E) into
position.
413 |
ACEC
