2.Make sure the camera is turned off.When charging is complete
If the camera is on, be sure to press [ON/OFF] to turn it off The [CHARGE] lamp, which was lit red during charging,
before placing it onto the USB cradle.changes to green.
Remove the camera from the USB cradle and unplug the AC
3.With the camera positioned so the monitor adaptor from the power outlet.
screen is facing towards you as shown in the
illustration, place it onto the USB cradle.If the [CHARGE] lamp lights amber
The [CHARGE] lamp lights red and charging starts.This indicates that charging cannot be performed because you
" It takes about three hours to achieve a full charge. Actual have just finished using the camera, or because the temperature
charging time depends on current battery capacity,
in your location is too hot or too cold. If this happens, wait until
remaining power, and charging conditions.the camera returns to normal temperature. When the camera
returns to a temperature where charging can be performed, the
[CHARGE] lamp will light red.
Cradle contact
Carefully insert the camera
as far as it will go.
[CHARGE] lamp
Camera contact
GETTING READY
38 |
ACEC
