OTHER RECORDING FUNCTIONS
4.Press the shutter release button to start voice Audio Recording Precautions
recording.Y Keep the microphone on the
Y The remaining recording time value counts down onfront of the camera pointed
the monitor screen and the green operation lampat the subject.
flashes as recording is performed.Y Take care that you do not
block the microphone with
Y Pressing the [DISP] button during voice recording
turns off the monitor screen. The monitor screenyour fingers.
turns back on automatically when recording is
complete.
Microphone
Y You can insert index marks while recording by
pressing [SET]. See page 106 for information aboutY Good recording results are not possible when the camera
jumping to an index mark during playback.
is too far from the subject.
Y Operating camera buttons during recording can cause
5.Recording stops when you press the shutter
button noise to be included in the audio.
release button, when memory becomes full,Y Pressing the power button or changing the mode selector
or when the battery goes dead.setting stops recording at that point and stores any audio
recorded up to that point.
NOTE Y You can also perform Oafter-recording� to add audio to a
snapshot after recording it, and also change the audio
Y You can also enter the Voice Recording Mode by
aligning the mode selector with OREC�, and holdingrecorded for an image. See page 104 for more
information.
down [DISP] as you press the power button to turn
on the camera. In this case, the camera goes directly
into the Voice Recording Mode without extending the
lens.
80 |
ACEC
