2253-2
ALARM MODECITY CODE TABLE
ModeWhen the Daily Alarm is turned on, the alarm
indicatorsounds for 20 seconds at the preset time each day.City CodeCityGMT differential
Press any button to stop the alarm after it starts toADLADELAIDE+9.5
Alarm onsound. When the Hourly Time Signal is turned on,
indicatorthe watch beeps every hour on the hour.ANCANCHORAGE�09
Hourly"The alarm sounds when the time selected for basicBERBERLIN+01
timetimekeeping in the Timekeeping Mode (TIME 1 orBKKBANGKOK+07
PM indicatorsignal onTIME 2) matches the alarm time you set.CAICAIRO+02
indicator
MinutesTo set the alarm timeCCSCARACAS�04
Hour1.Hold down AAAAA while in the Alarm Mode. The hourCHICHICAGO�06
digits flash on the display because they are
DACDHAKA+06
selected. At this time the Daily Alarm is turned on
automatically.DELDELHI+5.5
Current time2.Press CCCCC to change the selection in the followingDENDENVER�07
sequence.DXBDUBAI+04
HourMinutesGUMGUAM+10
3.Press DDDDD to increase the selected digits and BBBBB to decrease them. Holding downHKGHONG KONG+08
either button changes the selection at high speed.HNLHONOLULU�10
"The format (12-hour and 24-hour) of the alarm time matches the format youISTISTANBUL+02
select for normal timekeeping.
"When setting the alarm time using the 12-hour format, take care to set the timeJEDJEDDAH+03
correctly as morning (no indicator) or afternoon (P).JRSJERUSALEM+02
4.After you set the alarm time, press AAAAA to return to the Alarm Mode.
KBLKABUL+4.5
"If you do not operate any button for a few minutes while a selection is flashing,
the flashing stops and the watch goes back to the Alarm Mode automatically.KHIKARACHI+05
LAXLOS ANGELES�08
To switch the daily alarm and hourly time signal on and offLONLONDON+00
Press DDDDD while in the Alarm Mode to change the status of the daily alarm and
hourly time signal in the following sequence.MEXMEXICO CITY�06
MIAMIAMI�05
Alarm on indicatorHourly time signal on indicator
MILMILAN+01
MLEMALE+05
NOUNOUMEA+11
NYCNEW YORK�05
PARPARIS+01
PPGPAGO PAGO�11
Both ONBoth OFFDaily Alarm Hourly TimeRGNYANGON+6.5
OnlySignal Only
RIORIO DE JANEIRO�03
ROMROME+01
To test the alarm
Hold down DDDDD while in the Alarm Mode to sound the alarm.SELSEOUL+09
SFOSAN FRANCISCO�08
SINSINGAPORE+08
SYDSYDNEY+10
STOPWATCH MODE
THRTEHRAN+3.5
Mode indicatorThe Stopwatch Mode lets you measure elapsedTYOTOKYO+09
time, split times, and two finishes. The range of
WLGWELLINGTON+12
the stopwatch is 59 minutes, 59.99 seconds.
YVRVANCOUVER�08
*Based on data as of December 1997.
Current
time
Minutes
Seconds
1/100 seconds
(a) Elapsed time measurement
DDDDD¤DDDDD¤DDDDD¤DDDDD¤AAAAA
StartStopRe-startStopClear
(b) Split time measurement
DDDDD¤AAAAA¤AAAAA¤DDDDD¤AAAAA
StartSplitSplit releaseStopClear
(c) Split time and 1st-2nd place times
DDDDD¤AAAAA¤DDDDD¤AAAAA¤AAAAA
StartSplitStopSplit releaseClear
First runnerSecond runnerRecord time of
finishes.finishes.second runner.
Record time of
first runner.
AUTO DISPLAY FUNCTION
The Auto Display function of this watch continually changes the contents of the display.
Note that you cannot use any of the watchOs other functions while the Auto Display
function is operating.
To turn the Auto Display on
Hold down CCCCC for about two or three seconds in any mode until the watch beeps.
To turn the Auto Display off
Hold down CCCCC for about two or three seconds until the watch beeps. At this time the
watch is in the Timekeeping Mode.
Note
The Auto Display function cannot be performed while you are making settings (i.e.
while digits or other setting are flashing on the display). |
ACEC
