Starting a washing programme
In this fully integrated appliance the controls are located on the5. End of the washing programme
top of the door. When selecting a washing programme, the
door needs to be slightly open.The dishwasher will automatically stop. An audible signal
informs you of the end of the washing programme.
Open the dishwasherOs door, leave it ajar and wait a few
minutes before removing the dishes; in this way they will
1. Check that the baskets have been
be cooler and the drying will be improved.
loaded correctly and that the spray The end of cycleindicator light is on.
arms can rotate freelyThe indicator light of the programme just ended is on.
Switch off the dishwasher by pressing the On/Off button.
2. Turn on the water tap
6. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
3. Setting and starting the washing therefore be allowed to cool down before removing from
programmethe appliance.
Press the On/Off button.Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
The end of cycleindicator light flashes.
dishes in the lower one.
Press the programme selection/cancelbutton and select Water may appear on the sides and the door of the
the desired washing programme. To choose the right
dishwasher as the stainless steel will eventually become
washing programme see "Washing programmes" chart).cooler than the dishes.
Close the dishwasherOs door, the programme will start
automatically.When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
NOTE: the start of the washing programme will occur only
after the closure of the door. Until this moment it is water tap turned off.
possible to modify the selection made.
4. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if itOs absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasherOs door; the programme will stop.
Close the door; the programme will start from the
point at which it was interrupted.
Cancel a washing programme in progress
Open the dishwasherOs door. Press the programme
selection/cancelbutton for about 3 seconds, until the
indicator light of the running programme turns off and the
end of cycle indicator light flashes, indicating that the
running programme has been cancelled and that the
machine has returned to setting mode.
It is now possible to select another washing programme.
If a new washing programme is to be selected, check that
there is detergent in the detergent dispenser.
NOTE: onlyduring the drying phase, if the dishwasherOs
door will be opened and remains open for more then 30
seconds, the running programme will be automatically
cancelled and the machine will return to setting mode.
This will happen, always onlyduring the drying phase,
also when the machine is switched off by pressing the
On/Off button and remains switched off for more then 30
seconds.
12 |
ACEC
