132986250GB.qxd 09/02/2005 12:28 Pagina 103 (Nero/Process Black pellicola)
Place a bowl on the floor to collect any spillage. 7. Frost precautions
Pull out the emergency emptying hose, place it in
If the machine is installed in a place where the
the bowl and remove its cap.temperature could drop below 0°C, proceed as
When no more water comes out, unscrew thefollows:
Remove the plug from the socket.
Close the water tap and unscrew the water inlet
hose from the tap.
Place the end of the emergency emptying hose
and that of the inlet hose in a bowl placed on the
floor and let water drain out.
Screw the water inlet hose back on and reposition
the emergency emptying hose after having put the
cap on again.
pump cover and remove it.By doing this, any water remaining in the machine is
Remove any objects from the pump impeller byremoved, avoiding the formation of ice and,
rotating it.consequently, breakage of the affected parts.
Put the cap back on the emergency emptying hoseWhen you use the machine again, make sure that
and place the latter back in its seat.the ambient temperature is above 0°C.
Screw the pump cover fully in.
Close the pump door.
6. Emergency emptying out
If the water is not discharged, proceed as follows to
empty out the machine:
pull out the plug from the power socket;
close the water tap;
if necessary, wait until the water has cooled down;
open the pump door;
place a bowl on the floor and place the end of the
emergency emptying hose into the bowl. Remove
its cap. The water should drain by gravity into the
bowl. Whe the bowl is full, put the cap back on the
hose. Empty the bowl. Repeat the procedure until
water stops flowing out;
clean the pump if necessary as previously
described;
replace the emergency emptying hose in its seat
after having plugged it;
screw the pump cover again and close the door.
103 |
ACEC
