OPERATING INSTRUCTIONS
Turning Power On and Off
YTo turn the monitor power ON, press the main power
switch on the monitor main unit to ON, and then press
the SUB POWER button or the ON/OFF button on theENGLISH
remote control.
YTo turn the monitor power OFF, press the SUB POWER
Indicating lamp
button or the ON/OFF button on the remote control, and
then press the main power switch on the monitor main
Main power switch
unit to OFF.
Y During normal use, the main power switch is set in the ON
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the ON/OFF button on the remote control.
Indicating lamp
Indicating
Power statusOperating
lamp
When the main power switch is set
OffOff
to OFF.
When the main power switch is
ON, and the OFF button on the
Off
Lights redremote control or the SUB POWER
(standby)
button on the underside of the
front of the frame is OFF.
When the main power switch is
ON, and the ON button on the
Lights green Onremote control or the SUB POWER
button on the underside of the
front of the frame is ON.
When the main power switch is
SUB-POWER buttonON, and the ON button on the
remote control or the SUB POWER
Off
Lights orangebutton on the underside of the
(Power Save)
front of the frame is ON.
POWER ON/OFF
However, the state in POWER
button
SAVE mode
When the indicating lamp lights in orange or the message ONo Sync.
Signal�, OPower Save� or OInvalid Scan Freq.� appears on the screen,
there is something unusual about the status of reception.
See OPower Save Mode� or OSymptoms That Seemingly Appear to be
Failures.�
ATTENTION
Y Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
Y Turn off the main power switch before leaving the monitor out of
use for an extended period of time.
Y If a power failure occurs while the main unit is running, it would
be powered on upon recovery from the failure. Turn off the unit
main power switch before leaving the main unit. |
ACEC
