USING THE REMOTE TO CONTROL
DVD FUNCTIONS
Operating the precoded function for your DVD player.
This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of
your DVD player. (refer to page 31 for pre-codes)
1. Turn ON your DVD player.
2. Aim the remote control at the front of your DVD player.
3. Press and release the DVD/VCR button to switch to DVD pre-coded mode.
4. Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your DVD player, as shown on
page 31.
5. Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two
digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not
turn off, try a different two digit preset code.
6. The remote will now control your DVD player.
POWER
TVCBL/SAT DVD/VCR
NOTES:
1. If your DVD player cannot be operated after performingSWAP PIP MODE
PIPFREEZE
the above procedures, your DVD player?s code has not
PIP CH
been precoded into the remote.VIDEOMENU
2. In the unlikely event that your DVD player cannot be
operated after performing the above procedures, please
consult your DVD player operating guide.
SELECT
3. The remote control will remember the codes you have
programmed until the batteries are removed from the
MUTELAST CH
remote control. After replacing the batteries repeat theEXIT
entire programming procedure as stated above.
VOLCH
DVD/VCR Button
This button allows the remote to control your DVD player by
setting it to DVD mode.
123
PRECODED DVD Buttons456
These buttons transmit the chosen precoded DVD codes.
789
EXCLUSIVE TV ButtonsANT0INFO
These buttons are for operating the TV.
VID1VID2VID3VID4
RECASPECT VIRTUAL HD
VID5
CLU-4321UG
MY DVD PLAYER CODE IS:
NOTE:Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.
30 |
ACEC
