qUse only the correct voltage power outlet with safety ground connection.
100 - 120 V for USA, Canada, etc.
200 - 240 V for Europe. etc.
(This monitor automatically selects the input voltage 100 - 120/ 200 - 240V.)
qWall outlet should be close to the monitor and easily acessible.
FOR THE CUSTOMERS IN U.K.
THIS PRODUCT IS SUPPLIED WITH A TWO PINMAINS PLUG FOR USE IN MAINLAND EUROPE.
FOR THE U.K. PLEASE REFFER TO THE NOTES ON THIS PAGE.
NOTE:
ELECTRICAL CONNECTION
Your monitor requires an electrical supply of 240 volts - 50 hertz and should be protected by
a 5 amp fuse. Your equipment is supplied with a plug incorporating a 5 amp fuse fitted to the
mains lead.lf the plug that is fitted to the equipment is not suitable for your socket outlet, it
must be cut off and the appropriate plug fitted. The cut off plug should be disposed of, do
not insert it into a 13 amp socket to prevent the hazard of electric shocks. With plugs not
incorporating a fuse, the circuit must be protected by 5 amp fuse.
WARNING: THIS EQUIPMENT MUST BE EARTHED
IMPORTANT:
Your equipment is supplied with a mains lead, the wires of which are coloured inaccordance
with the followingcode: Green and Yellow - Earth, Blue - Neutral, Brown - Live.
Green & YellowBrown to Live
to Earth
Fuse
Blue to Neutral
Cord Clamp
As the colours of the wires in your mains lead in this equipment may not correspond with the
markings identified with the terminals of your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug
which is marked with the letter E or by the earth symbol4 or coloured Green or Green and
Yellow.
The wire which is coloured Brown must be connected to the terminal which is marked with
the letter L or coloured Red.
The wire which is coloured Blue must be connected to the terminal which is marked N or
coloured Black.
The plug moulded on to the cord incorporates a fuse. For replacement, use a 5 amp BS1362
fuse. Only ASTA approved fuses should be used. The fuse cover/carrier must be refitted when
changing the fuse. In the event of losing the fuse cover/carrier, the plug must not be used
until a replacement has been obtained from your nearest electrical stockist and fitted. tile
colour of the fuse cover/carrier is that of the coloured marks onthe insert in the base of the
plug.
6 |
ACEC
