OPERATING INSTRUCTIONS (continued)
Volume Adjustment
The volume can be adjusted by pressing the VOL+ and
VOL- buttons of the remote control (or the and
volume buttons of the monitor unit) while the on-screen
display system is not being displayed.ENGLISH
Volume setting value
�Ű
VOLUME buttons
VOLUME 15
INPUT SELECT button
Adjustment status guide display
� When a button is pressed, the volume adjustment
status guide will be displayed.
� The volume will increase when the VOL+ (or ) button is
VOLpressed while the guide is being displayed.
� The volume will decrease when the VOL- (or ) button is
VOLUME
MUTEVOLpressed while the guide is being displayed.
UP/DOWN buttons
MUTE button� The volume can also be adjusted with the on-screen
AUTOPinPSIZERECALLdisplay system.
RGB/VIDEORGB 1RGB 2VIDEO 1 VIDEO 2
buttons
MENURETURN
Audio Mute
ENTER
The audio volume can be temporarily lowered to the
IDID SETmute volume level by pressing the MUTE button of the
remote control.
Volume setting value
VOLUME 15
Input Switching
Adjustment status guide display
KKInput can be switched by pressing the RGB1, RGB2,(The display color will change to pink.)
VIDEO 1 or VIDEO 2 buttons of the remote control.
KKInput can be switched in the sequence of RGB1 ��
RGB2 VIDEO 1 VIDEO 2 by pressing the INPUT� When a button is pressed, the word MUTE (in pink) and����
SELECT button of the monitor.the volume adjustment status guide will be displayed.
� The volume setting can be lowered by pressing the VOL- button
while the audio is muted.
� The muting can be cancelled by pressing the VOL+ button while
the audio is muted.
When INPUT SELECT is pressed:
� When audio is muted with the on-screen display
RGB1 (D-sub input)
system, the volume setting can be adjusted.
RGB2 (D-sub input)
When the MUTE button of the remote control is pressed
VIDEO1 (composite or S input)
again, muting will be canceled, the volume display (blue)
VIDEO2 (component input)will appear and sound will be output.
� If the video unit is not installed, you cannot switch to VIDEO1 and
VIDEO2.
� When the same signal is input to RGB1 and RGB2, the phases may
be slightly misaligned. This is not a malfunction. In such case,
please change one refresh rate (Vertical frequency ) of the
apparatus to be used. |
ACEC
