Installation Location
WARNING
Plaster board orÅ® The wall where the wall-mount unit is to be
thin ply wood, etc.
installed must be capable of long-term
support of the total load of the plasma display
and wall-mount unit. Measures should also be
taken to ensure sufficient strength to
withstand the force of earthquakes, vibration
and other external forces.
Incorrect installation can cause the plasma display to fall
and cause injury.
Pillar or
thick ply wood.
Model 50 Total load of the (plasma display + wall-mount unit) = 52.7kg
�Installation on a wooden wall
Always install so that the load is supported by a piller. If the
strength of the piller is insufficient, add reinforcement. Do
not install on plasters or decorative posts.
�Installation on a concrete wall
Use commercially available anchors that are capable of
fully supporting the load of the plasma display.
CAUTION
Å® Avoid installing inÅ® Do not block the
locations where the10cmventilation holes.
temperature andor more Also provide
humidity aresufficient clearance
excessively high,10cmin regard to the
or more
and where contactsurroundings to
with water isavoid blocking the
possible.ventilation.
10cm
These can result in fireor more The internal
or electrical shock.temperature could
elevate and possibly
result in fire.
Å® Do not install closeÅ® Mount only on a
to an air-vertical, rigid wall
conditioner intakesurface.
or outlet.The internal
Do not install intemperature could
locations whereelevate and possibly
there is excessiveresult in fire.
amounts of dust,Injury or damage could
oily smoke oralso result from falling.
tobacco smoke.
Fire could result.
?? |
ACEC
