Power on/off
Power on/off
WARNING yWhen the power is on, a strong light is emitted. Do not look into
the lens of projector. Also do not peep at the inside of projector through a hole.
NOTE Turn the power on/off in right order. Please power on the projector prior
to the connected devices. Power off the projector later than the connected devices.
VIDEORGBSEARCH
ASPECTAUTOBLANK
MAGNIFYPOWER ONVOLUME
MUTESTANDBY/ON OFFindicator
FREEZEKEYSTONEbutton
POSITIONMENU
ENTER
ESCRESET
Power switch
Turning on the power
POWER
Make sure that the power cord is rmly and correctly
1. (Steady orange)
connected to the projector and the outlet.
POWER
Remove the lens cover, and set the power switch to
2.
the ON position. (Blinking in green)
The power indicator will light up in steady orange. Then
POWER
wait several seconds because the buttons may not
function for these several seconds. (Steady green)
Press the STANDBY/ON button on the projector or the remote control.
3.
The projector lamp will light up and the POWER indicator will begin blinking
in green. When the power is completely on, the indicator will stop blinking and
light in green.
To display the picture, select an input signal according to the section "Selecting an
input signal" (&&17).
Turning off the power
Press the STANDBY/ON button on the projector or the
1. Power off?
remote control.
The message "Power off?" will appear on the screen for
approximately 5 seconds.
POWER
Press the STANDBY/ON button on the projector or the
2. (Blinking in orange)
remote control again while the message appears.
The projector lamp will go off, and the POWER indicator
will begin blinking in orange. POWER
Then the POWER indicator will stop blinking and light in (Steady orange)
steady orange when the lamp cooling is complete.
Make sure that the power indicator lights in steady orange, and set the power
3.
switch to the OFF position. The POWER indicator will go off. Attach the lens cover.
16 |
ACEC
