SAFETY INSTRUCTIONS
Pull inCare and storage
Pull in occurs when the lower part of the blade is suddenly
stopped or when the cut closes. (To avoid this see the section
�How to avoid kickback� and �Pinching/rotation� below).General
HusqvarnaOs power cutters are robust and durable. However, as
Pinching/rotationthey are used for high speed operations all servicing should be
Pinching occurs when the cut closes. The power cutter can becarried out on time and as specified, so that the power cutter
drawn suddenly and powerfully downwards.always works effectively and safely.
Read this OperatorOs Manual to determine which service
How to avoid pinching
Support the work piece inroutines you can carry out and ensure that all other service
work is carried out by an authorised service workshop.
such a way that the cut
remains open during the
Power Cutter
cutting operation and when
the cut is finished.Always handle the power cutter with care and store it with the
blade removed.
Drying the blade
After using the blade withBlades
water cooling, let the cutterY All blades should be
run for approx. half a minuteremoved from the cutter
so that the blade dries.after use and stored
carefully.
If a damp blade is stored it
can become unbalance andY Special care should be
cause damage.taken with abrasive
blades.
Check the speed of the
Y Blades must be stored on
drive shafta firm, level surface. If
Use a tachometer regularly to
blades are supplied with a
check the speed of the drivebacking pad then a spacer
shaft when the cutter is
running at working tempera-should be used to keep
them flat.
ture and at full throttle without
a load. The maximum speed
Y Avoid moisture and
is stated on the unit.temperature extremes.
Y Remove the blades before
the cutter is moved or
WARNING!transported.
If the speed is higher than that stated then the
!unit must be adjusted by an authorisedY Inspect new blades for
service workshop before it is used.transport or storage
damage.
English � 9 |
ACEC
