ASSEMBLY
Assembling the loop handlebarAssembling and dismantling the
(322C, 323C, 325C)two-part shaft
X
(323LD, 325L, 325LD)
Y Position the handle onXTX
the shaft. Note that the
Assembling:
handle must be mounted
below the arrow on the
Y Make sure the handle is
shaft.
loose.
Y Fit the bolt, securing plate
Y Guide the cut-out on the
and wing nut as shown in
lower section of the shaft
the diagram.
into the coupling�s
locking plate on the
Y Tighten the wing nut.
upper section of the
shaft. The sections are
then locked together.
Y Tighten the handle.
Dismantling
Y Undo the handle (at least
three turns).
Y Press the handle towards
the coupling.
Y Carefully twist the lower
section out of the lock.
Assembling the loop handlebar
Y Hold both parts of the
(322L, 323L, 323LD, 325L, 325L, 325LD)
XXTXshaft and pull out the
lower section from the
Y Clip the loop handle ontocoupling.
the shaft. Note that the
loop handle must beAssembly of the trimmer head
fitted between the arrows
on the shaft.It is extremely important
that the disc driveOs/support
Y Slide the spacer into theflangeOs guide engages
slot in the loop handle.correctly in the cutting
equipmentOs centre hole
Y 322L/323L/323LD: Fitwhen assembling the cutting
the nut, washer and bolt.equipment. Cutting
325L /325L /325LD :equipment assembled
XXTX
Fit the nut, knob andincorrectly can result in
bolt. Do not overtighten.serious and/or fatal personal
injury.
Y Now adjust the trimmer
to give a comfortable
working position. Tighten
the bolt/knob.WARNING!
Under no circumstances may the cutting
equipment be used without an approved
!
guard fitted. See the chapter OTechnical
data�. If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
12 � English |