ASSEMBLY
TO DRIVE THE MOWER OFF OF THE
Adjustments may be required to get uniform
SKID (See Operation section for location
positioning of the control lever. Refer to the
and function of controls)
"Service and Adjustment" section of this manual.
NOTE: You may now roll or drive the mower off
of the skid. Follow the appropriate instructionWARNING
below to remove the mower from the skid.
Before starting, read, understand and
follow all instructions in the Operation
section of this manual. Be sure the
mower is in a well-ventilated area. Be
sure the area in front of the mower is
CONTROL
clear of other people and objects.
LEVER
CONTROL Be sure all of the above assembly
ARM
steps have been completed.
Check engine oil level and fill fuel
tank with gasoline.
Place the IZT(Integraded Zeroturn
HEX
Transaxle) bypass linkages into theBOLTS
drive position (See ?TRANSPORT? in
the Operation section of this manual).
NEUTRAL
Sit on the seat in the operating posi-
SLOT
tion, set the park brake lever to the
CZ-2
on position.
FIGURE 2
Rotate the control levers outward
into the neutral slot.
TO ROLL THE MOWER OFF OF THE SKID Press forward on the deck lift pedal
(See Operation section for location andto raise the deck into the highest
function of controlscutting position.
Place the throttle control into the
Move to the rear of the mower, and place
choke position.
the IZT (Integraded Zeroturn Transaxle)
Start the engine. After the engine
bypass linkages into the bypass position
has started, move the throttle control
to disengage the IZT?s (See ?TO TRANS-
to the idle position.
PORT? in the Operation section of this
Release the park brake.
manual).
Move the control levers into the
Sitting on the mower, press the deck lift
operate position.
pedal in to the highest cutting position.
Slowly move the control levers for-
Release park brake lever.
ward and slowly drive the mower off
Roll the mower forward or backward off
of the skid.
of the skid.
Return the control levers back to the
neutral position.
Apply the park brake.
Turn the ignition key to the ?OFF?
position.
13 |
ACEC
