IMPORTANT INFORMATION ABOUT THE WASHING MACHINE FUNCTION
1. Your washing machine does not start immediately3. Spinning has an interrupted start-up - the drum
after switching it on - but it begins to fill water onlystarts and stops running several times - it is so
after 15-20 seconds, that is the time needed for thecalled interval spinning with an increased
electric door locking. The drum starts rotating onlyspinning efficiency.
after filling certain amount of water.
4. Front part of the top frame and the cabinet can
2. When washing cotton and resistant synthetics, theget warm from the electric door lock, which is
program does not end after final spinning finish butnot a fault.
the drum goes on reversing up to circa 3 min (its
rotation alters in one and another direction), which
helps to release the laundry after spinning.
INTERRUPTING THE WASH PROGRAMME
If you want to change selected programmeEnd of the wash programme
1. Select a new programme using the selector knobThe programme is completed when the programme
selector knob stop on a STOP position.
If you want to add another piece of laundry, you
can interrupt the washing cycle at any time:Turn off the water tap and disconnect the machine from
1. Switch OFF the washing machine by adjustingthe mains.
timer knob to position STOP.
2. The door is electrically closed during the wholeThe safety device will keep the door locked at the end
washing cycle, so you must wait oneminuteof the wash cycle for approximately one minute.
approx. for the door safety device to release.
3. Open the lid, the inner door and the drum flaps.1. Open the machine lid, the inner door and drum flaps .
Add the items to the wash load..2. Remove the laundry, pay attention not to drop small
4. Close the drum flaps, the inner door and the lid.items between the tub and the cabinet.
5. The timer knob adjust to the same position as it
was before working cycle interruption. Washing
machine will continue in selected work cycle.
9 |