NC
INSTALLATION INSTRUCTIONS
ELECTRICAL CONNECTION
xElectricalconnectionsmustbemadein
accordance with local regulations.
xTheelectricalconnectionmustbemadeonly
by means of a Shuko socket with earth
connection, installed in accordance with
established legislation.
xVoltage,powerconsumptionandearthing
information is shown on the service sticker
inside the door.
xThemainsconnectionlinemustbereplaced
by a licensed electrician only.
Connection to a
xTheappliancecomplieswithEuropeansafetytypical 13 amp plug
standards, EC directive 93/68 and EN
directive 60555
FOR GREAT BRITAIN ONLY
HOW TO CONNECT A PLUG
The wires in this mains lead are colourîcoded as
follows:
BLUE î NEUTRAL �NO
BROWN î LIVE �LO
GREEN AND YELLOWîEARTH �EO
1. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which
is marked with the letter oEó or by the Earth
symbol4, or coloured green or green and
yellow.
2. TheBLUEwiremustbeconnected to the
terminal which is marked with the letter N or
WARNING î THIS APPLIANCE
coloured black.
MUST BE EARTHED
3. The BROWN wire must be connected to the
Some appliances are supplied with mouldedterminal which is marked with the letter L or
plugs. To change a fuse on this type of plugcoloured red.
proceed as follows:
1. Remove fuse cover �AO and fuse �BO
2. Fit new fuse which should be a BS 1362FOR THE REPUBLIC OF IRELAND
13A, A.S.T.A.ONLY
The information given in respect of Great Britain
IMPORTANT:
will frequently apply, but a third type of plug
xThefusecovermustberefittedafter
and socket is also used, the 2îpin, side earth
changing a fuse
type. In this case the GREEN AND YELLOW wire
xIntheeventofafusecoverbeingmisplaced,
must be connected to the EARTH contact and
the plug must not be used until a correct
the other two wires to the terminals of the two
replacement is fitted.
pins, irrespective of colour.
xPleaseensurethatthereplacementfuse
cover is of the same colour as the insert or
as the colour embossed in words on the
base of the plug.
If the moulded plug is not suitable for your
sockets it should be cut off and thrown away to
avoid any risk of electric shock if it were used in
a 13 A socket elsewhere.
A suitable alternative plug should then be fitted
to the cable.
16
MY |
ACEC
