00000gb.fm5 Page 12 Wednesday, May 10, 2000 3:42 PM
DRAINING RESIDUAL WATER
WHEN TO DRAIN RESIDUAL WATER5. Wait until the flow stops.
? If the filter needs to be cleaned during a Note: There can be up to 20 litres of water in the
programme.machine during a programme.
Note: Make sure that the water has cooled 6. Clip the drain hose again on the rear part of
before draining.the machine.
Note: There can be up to 20 litres of water in the 7. Replace the drain hose with the ?U? bend and
machine.fix it.
? When transporting or moving the machine.
? If there is danger of freezing in the installation
room. In this case the machine and the hoses
should be drained after every wash.
DRAINING RESIDUAL WATER
1. Switch off the appliance.
2. Unplug the machine from the mains.
3. Unclip the drain hose connection on the rear
part of the machine (see arrow).
4. Lower the drain hose into a container and let
the water drain.
Note: Make sure that the water has cooled
before draining.
WASHING MACHINE INSTALLED IN ROOM
EXPOSED TO FREEZING TEMPERATURES
Drain residual water from the machine, and
the inlet hose after every wash cycle.
1. Switch off the appliance.
2. Unplug the machine from the mains.
3. Close the tap, loosen the inlet hose from the
machine and let the water drain out.
4. Open the filter, let the water drain out and
close it again.
Note: Before a new wash cycle screw the inlet
hose to the machine by hand. Check water-
tightness of washing machine connections by
turning the tap completely on.
12 |
ACEC
