Enjoying music or videos with the DTR-6.2
Jog dialSLEEP
DisplayDimmerCH Level
Standby/OnRec OutZone 2Zone 2 LevelCH LevelMaster Volume
DSP/Mode ADJSetupCH SELMUTING
StandbyReturn
Power
OnO f fDisplayDimmerFM ModePreset MemoryTuningPresetSmart Scan NavigatorPush To Enter
LEVEL
PhonesSelectorAudioDVDVideo 1Video 2Video 3Video 4TapeFMAMPhonoCDBassTreble
VCR 1VCR 2
DISPLAY
HOME THEATER RC-441MCONTROLLERDIMMER
Switching the displayUsing the sleep time (remote controller only)
While listening to or watching an input source, you can display theThe SLEEP button enables you to set the DTR-6.2 to turn off
information regarding the type of source and signal being input byautomatically after a specified time period. If you press it once, the
pressing theDTR-6.2 will turn off after 90 minutes. Each time it is pressed
thereafter, the remaining time until the DTR-6.2 turns off decreases
button on the DTR-6.2 or the DISPLAY button on the remote
by 10 minutes. While, the sleep function is enabled, you can press
controller.
the SLEEP button to see how much time is left. To cancel the sleep
DTR-6.2Remote controllerfunction, press the SLEEP button when the time displayed is less
Display
than 10 minutes.
If you are using the remote zone (Zone 2), it will turn off at the same
time as the main zone. If you want to set the sleep function for Zone
When an input source other than FM or AM is selected:2 only, set the sleep function with main zone turned on and then put
the main zone into the standby state.
Remote controller
Input + volume
Program format*
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the
Input +
procedure given below. Each channel can be set between �12 to +12
Listening mode
decibels. Note that the calibration settings will return to the original
or Multi Ch
settings when the DTR-6.2 is put in standby.
CH Level
* If the input signal does not have a program format, then this will
1. Press the CH Level button and select
be skipped.
the desired speaker.
DSP / Mode ADJ
When FM or AM is selected as the input source:2. Turn the jog dial to adjust the
volume level.
Push To Enter
FM/AM frequency +
ch
Preset no.When using the remote controller:
1. Press the RCVR MODE button.
FM/AM +
Listening mode
2. Press the CH SEL button and select
the desired speaker.
Adjusting the brightness of the front display3. Press the LEVEL or button to
adjust the volume level.
You can adjust the brightness of the front display of the DTR-6.2
with DIMMER button on the remote controller or Dimmer buttonNotes:
on the DTR-6.2 front panel.Y You cannot select a speaker if the Speaker Config sub-menu of
the Speaker Setup is set to No or None.
DTR-6.2Remote controller
DimmerY If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
Y When you press the TEST button after you set the level, the
current level will be used as the value set via the test tone.
30 |
ACEC
