INSTALLATION
INTERMOUNT III (patent no.FLUSH-MOUNTTWEETER ANGLEFigure 7A. Surface-mounted behind
6,505,705) MOUNTING RINGSFigure 5A. Mounting the tweeter using the Figure 6. Aim the tweeter at the listeninggrille panel.
The GTO607C is packaged with two I-Mount �ush-mounting kit.position by sliding the screw in the groove
different speaker adapters. The adapterson the back of the tweeter cup and lock the
will allow the speakers to be installed intotweeter in place using the small retaining
various factory 6," 6-1/2" and 6-3/4" openings.screw. Rotate the entire assembly in the
The metal adapter can be mounted in manymounting surface and tighten the large
European vehicles, Japanese vehicles orhand nut.
vehicles with 6" speaker locations. The
plastic adapter can be mounted in many
vehicles using 6-3/4" speaker locations orFigure 7B. Flush-mounted to surface behind
three-point mounting frames.grille panel.
Figure 3. Mounting the GTO607C using theSURFACE-MOUNT
supplied metal adapter. Mounting with theFigure 5B. Mounting the tweeter using the
plastic adapter is similar.I-Mount surface-mounting cup.
Figure 7C. Mounted to grille panel.
a
Figures 7A through 7D. The StarŢsh
tweeter mount is intended to be used
when the tweeter will be installed behind
a factory grille (e.g., replacing the factory
tweeter behind a door panel). The StarŢsh
will allow you to mount the component
tweeter directly to the panel itself or to the
area behind the panel. The six mounting
Figure 4. Mounting the GTO607C woofertabs can be removed easily to create aFigure 7D. In-dash location
without the metal adapter.number of custom conŢgurations.may require gluing
Note: Check screw clearance before
installing. Use glue if clearance is an issue.
Note: Not all possible mounting
conŢgurations are shown.
3
4SECURELY TIGHTEN
THE LARGE HAND NUT.2TIGHTEN SCREW TO
LOCK ANGLE SETTINGS.3ROTATE ENTIRE ASSEMBLY
TO AIM ANGLED TWEETER
TOWARD LISTENER.1SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
FOAM GASKET
FOAM GASKETMOUNTING RING |
ACEC
