GTQ 360 new 7/17/98 10:44 AM Page 6
Cassette/CD Tuner A. Satellite/SubwooferSubwoofer (Low-Pass)
Speaker-Level Output Connection
(Use only when line-level output
is not available)(�)(+)
Cassette/CD TunerCD PlayerHigh-Pass Satellite Crossover Frequency: 100HzTweeter/Midrange Satellites
or Changer
C: 300?F capacitorLeft(High-Pass)Right
100V, non-polarized
(�)(+)(+)(�)
Subwoofer Low-PassL
Crossover Frequency: 100Hz
Antenna InputCC
CD InputL: 6.2mH air core inductor
PowerCassette/ReceiverAmplifierSpeaker
AntennaPower SupplyLevel
WiresInputs
GTQ360
PowerAmplifier
AntennaCassette/CD Preamp OutputPowerAmplifierSpeakerLINE LEVELPREAMPSPEAKER LEVEL INPUTSSPEAKER OUTPUTS (BRIDGED: R+TOL�)POWER
RelayConnectionOutputGR1INPUTOUTPUTS+�R GR2 L�++L GR1 +++L R GR2 RIN/OUTREMGR2GR1GR2FUSEFUSEMUTE
FuseFuseConnection30A30AL
+��+30A30A
RR GR1 L
Antenna MotorPower Supply����BATT(+)GND
Remote On/Off
Blue (Blue/White)Remote AntennaBlack - Power GroundRed - Main +12V+*You may change the subwoofer satellite crossover frequency by using the
Inductor and Capacitor values calculated with the following formulas:
Yellow - Back Up Power
�Speakers30,000
Blue w/White Stripe - Remote On/OffHigh-Pass (Satellite Crossover): = New Capacitor Value in Desired crossover Frequency in Hz?F
Amplifier
Ignition SwitchSpeaker+Output620
+Low-Pass (Subwoofer Crossover): = New Inductor Value in mH
ConnectionDesired crossover Frequency in Hz
(Not Included)Center Channel
Fuse�SpeakersB. Center ChannelBridged Speaker Connection*
Main +12V
�+
Amplifier+
Vehicle BatterySpeakerOutput(�)8 1 Minimum(+)
Connection8 1 L-Pad
Power Ground(Optional but Recommended)
GTQ360
Chassis GroundLINE LEVELPREAMPSPEAKER LEVEL INPUTSSPEAKER OUTPUTS (BRIDGED: R+TOL�)R GR2 LL GR1 L R GR2 RREMPOWER
INPUTOUTPUTS
GR1+��+++++IN/OUTGR2GR1GR2FUSEFUSEMUTE30A30A
L
+��+30A30A
RR GR1 L
draws negligible current so a relativelyhead unit speaker-level outputs to the����BATT(+)GND
small (18 or 20 gauge) wire may be used.GTQ ampliŢer speaker-level inputs and* Center Channel Speaker Minimum 8 Ohms, Main
Speakers Minimum 4 Ohms When Used Simultaneously.
Y Using the REM-OUT feature � The REM-connect the REM-IN/OUT terminal to the
IN/OUT terminal of the GTQ ampliŢerremote-in terminal of other ampliŢers or
may be used to turn on other ampliŢerssignal processors. The GTQ ampliŢer will
(+)(�)(�)(+)
when the GTQ ampliŢer is being turnedturn on the other amps or processorsStereo, Non-BridgedSpeaker Connection*
on by the Common Sense circuitry in thewhenever the Common Sense circuitry41 Minimum41 Minimum
speaker-level input. Simply connect theturns on the GTQ ampliŢer.Simultaneous Stereo-Mono Connection Diagrams
6 |
ACEC
