G E T T I N G S T A R T E D11
POWER
r Make sure that the TV/CATV switch is set to TV. Switch to CATV only to operate a cable box.
r P ress the PO W E R button on the remote control or the TV front panel. The On Timer lamp will glow red.
r The Ţrst time you turn on the TV, the OPlug In Menu� will appear. You should turn to the Plug In
Menu section (page 15) now to learn more about this menu.
r To turn the power off, press the POWER button again. The On Timer lamp will go out.
r When the TV is off, the OnTimer lamp remains on while the On/Off Timer function is active, but at a
reduced brightness.
ADJUSTING VOLUME
Use the VOLUME �/+ buttons ( ) on the front panel or remote control. Use the VOLUME � ()1
button to lower the volume. Press the VOLUME + button ( ) raise the volume.
VOLUME 13
|||||||
-------------------
Press the MUTING button to instantly turn the volume off to zero. To restore the volume to the
2
previous volume level, simply press the MUTING button again.
CHANGING CHANNELS
110 key direct access.
Press the numbers on the remoteOs 10 key pad. For single-digit channel numbers press 0 then the
number. For channels above 100, press the 100+ button plus the 2-digit number.
2Ch/Hyper Scan button.
Y To scan the channels one at a time,p ress the remote's CH/ HY P E R SC A N button and re l e a s e .
Y To scan through the channels very quickly,hold down the remote's CH/ HY P E R SC A N button.
After two channels go by at normal speed, the rest of the channels will speed by at the rate of Ţve
channels per second. You will not see pictures on the channels, only the changing channel numbers at
the bottom of the scre e n .
3Return.
Press and release the RETURN+ button to return to the previous channel. First, select a channel
(game #1). Then, select another channel (game #2) with the 10 key pad and push the RETURN+
button to �ip directly back and forth.
4Return+ .
Press and hold down the RETURN+ button for three seconds. The message, ORETURN CHANNEL
PROGRAMMED !� will appear and you can scan as you wish. Press RETURN+ again and you will go
back to the Return+ channel.
To cancel a Return+ channel, press and hold down the RETURN+ button for another three seconds
and the message, ORETURN CHANNEL CANCELLED !� appears.
r Pressing a number key or turning the set off will also cancel a Return+ channel. |
ACEC
