DD: JVC STATUS SENSE Setup (preset) commands
This section describes 4-byte data that are returnedThese commands are for setting various types of VCR
when the STATUS SENSE command is sent.data. The commands corresponding to the settings
can be transmitted.
First byte
Bit No.Status: If the bit is 1
Table CommandDescription
7Always 1
BE0TC DATA PRESET :
6Always 0
For presetting the time code data. To
5Unused:Always 0
set, transmit the time data following
4DMF:Playing back LP-mode tape
this command. Specify the time in or-
3Unused:Always 0
der of hour, minute, second and frame,
2JVC TABLE2:JVC TABLE 2 enabled
using two digits for each. When EN-
1JVC TABLE1:JVC TABLE 1 enabled.
TER (40h) is transmitted before all dig-
0LOCAL:REMOTE switch set to LOCAL
its have been transmitted, the time
code data are specified by entering
Second bytedigits from the uppermost digit.
BE1TC UB DATA PRESET :
Bit No.Status: If the bit is 1
For presetting the userOs bit.
7TC GENERATOR :Time code generator in the TCGE3IN DATA PRESET :
mode.For presetting the edit-in point. Set by
6USER BIT:Counter mode set to the UBtransmitting time data following this
mode.command.
5TIME CODE:Counter mode set to the TCSpecify the time in order of hour,
mode.minute, second and frame, using two
4CONTROL PULSE :Counter mode set to the CTLdigits for each.
mode.If ENTER (40h) is transmitted before
3CTL completion:Always 0all digits have been transmitted, this
2DROP FRAME:Current time code in the DROPcommand is executed with unspecified
FRAME modeparts set as O0.�
1LTC:Always 1If this is a negative value in the CTL
0Unused:Always 0mode, set 38h to the digit of 10H.
E4OUT DATA PRESET :
For presetting the edit-out point.
Third byte
For details, refer to IN DATA PRESET
Bit No.Status: If the bit is 1(E3h) above.
BE5EDIT PRESET :
7TC REC RUN:TCG set to the Rec Run mode
For selecting the edit mode. Each bit
6TC REGEN:TCG set to the REGENERATION
is defined as shown in the table be-
mode
low.
5TC EXTERNAL:TCG set to the EXT mode
4TC INSERT LED:Time code insert edit mode7654
3AUD1 INSERT LED :Audio-1/2 insert edit mode0011
First
2AUD2 INSERT LED :Audio-3/4 insert edit mode3210
byte
1VIDEO INSERT LED:Video insert edit mode0INS ASM Video
0ASSEM:Assemble mode
0011
Second3210
Fourth bytebyte
0TC Aud-1 Aud-2
Bit No.Status: If the bit is 1
Y ENTER (40h) is invalid.
7TBC PWB IN:Always 1
BE6PREROLL TIME PRESET :
6TC PWB IN:Always 1
For setting the preroll time. Specify this
5DA3 INSERT LED :Always 0
by transmitting 2-byte data following
4DA4 INSERT LED :Always 0
this command. First byte for tenOs place
3AUTO MODE: Auto editing/Previewing/Review-and second byte for oneOs place.
ing
2Unused:Always 0
1Unused:Always 0
0Unused:Always 0
91
DV6000U_72-104_Eng.p65e9103/04/03, 3:11 PM |
ACEC
