Playing Back Tapes
English
You can play back type I, type II, and type IV tapes withoutTo play both sides repeatedly N Reverse Mode
changing any settings.Reverse Mode works for both decks at the same time.
When it is in use, the tape automatically reverses at the end of
Playing Back a Tapea side and the unit starts playing for the other side of the tape,
and repeats the same process.
To use Reverse Mode, press
1Press EJECT (0) for the deck you want toREVERSE MODE so that the Reverse Mode
use.indicator on the display lights up lik.e N
To cancel Reverse Mode, press the button
again so that the Reverse Mode indicator on the
display lights up lik. e N
For Deck B
When Reverse Mode is on with cassettes in both decks
A and B
After the rev2e) side of the tape frse (inishes playing, the tape in theFor Deck A
2Put a cassette in with the exposed part of theother deck starts playing.
tape down.
Locating the Beginning of a Song
N Music Scan
You can use Music Scan to locate the beginning of a song.
Music Scan searches for blank portions that usually separate
recorded songs, then plays the next song.
3Close the cassette holder gently.To find the beginning of the current song
If you put cassettes in both decks A and B, the last decDuring play, press 1k or � (4 or
you have put a cassette into is selected.c on the remote control) in the opposite
To select the other dec press k,TAPE A/B.direction to the tape play.
The tape direction indicator of the opposite
4Press TAPE 2 3.direction to the tape play starts flashing
The tape play starts and the tapeslowly.
direction indicator (3 or 2) startsSearching stops automatically at the beginning of the current
flashing slowly to indicate the tape
song, and the current song starts automatically.
running direction.
Y Each time you press the button, the
To find the beginning of the next song
tape direction changes.During play, press 1 or � (4 or
33333 : plays the front side.
c on the remote control) in the same
22222 : plays the reverse side.direction as the tape play.
Y If no cassette is inserted, ONO TAPE� appears on the
The tape direction indicator of the same
display.
direction as the tape play starts flashing
When the tape plays to the end, the deck automaticallyslowly and quickly alternately.
stops if the Reverse Mode is off. (See OTo play both sides
Searching stops automatically at the beginning of the next
repeatedly N Reverse Mode.�)song, and the next song starts automatically.
To stop playing, press 7.Music Scan works by detecting a 4-second long blank
To operate the other deck, press TAPE A/B,between each song, so it will not work well in the
then TAPE 2 3.following cases
Y No blank at the beginning of a song.
To fast-wind to the left or to the rpressight, Y Noise (often caused by much use or poor quality dubbing) which
1 or � (4 or c on the remote control) while thefills the blank.
tape is not running.Y Long, very soft passages or pauses in a song.
The tape direction indicator (3 or 2) starts flashing quickly
on the display.The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
To remove the cassettepress 0, EJECT for deck A ormay occur and this tape easily jams in the pinch-
EJECT 0 for deck B.rollers and the capstans.
� 17 �
EN13-17.CA-MXGT90&80&70[UJ,UW]f173/21/01, 6:25 PM |
ACEC
