Continued
Recording
English
IMPORTANT:Recording Tapes on Deck B
Y It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
Y The recording level is automatically set correctly1Press EJECT , so it is0 for the deck B.
not affected by the VOLUME control. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
Y While recording, you can hear sound modes and/or the
Active Bass Extension effect through the speakers or
headphones. However, the sound is recorded without these
effects (see page 10).
Y If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance2Put in a recordable cassette, with the exposed
between the TV and the unit.part of the tape down.
Y You can use type I and II tapes for recording.
3Close the cassette holder gently.
To protect your recording
Cassettes have two small tabs on the back to protect
4Check the tape direction of deck B.
unexpected erasure or re-recording.Y If the tape direction is not correct, press 2 3TAPE
To protect your recording, remove these tabs.
twice then 7 to change the tape direction.
To re-record on a protected
tape, cover the holes with
5Start playing the source N FM, AM*, CD
adhesive tape.
player, deck A, or auxiliary equipment
When using type II tape, be
connected to AUX jacks.
careful not to cover the holes
Y When the source is CD, you can also use CD Direct
used to detect the tape type.
Recording (see page 19).
Y When the source is deck A, you can also use the
To keep the best recording and playback sound quality
dubbing method. (See ODubbing Tapes� on page 19.)
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:* See OTo record an AM (MW/LW) station � Beat Cut� on page
19.
Y Impaired sound quality
Y Discontinuous sound
Y Fading6Start recording.
Y Incomplete erasureOn the unit:
REC
START/STOP
Y Difficulty in recordingPress REC START/STOP.
The indicator lights up on the display and
To clean the heads, capstans, and pinch rollersrecording starts.
Use a cotton swab moistened with alcohol.
On the remote control:
Pinch rollers1) Press REC PAUSE.REC PAUSE
Capstans
The indicator starts flashing on the
display.
2) Press TAPE 2 3.
The indicator stops flashing and
remains lit, and recording starts.
Heads
To stop during recorpress REC STding, ART/
To demagnetize the headsSTOP again (or 7 on the remote control).
Turn off the unit, and use a head demagnetizer (available at
electronics and record shops).
� 18 �
EN18-24.CA-MXJ30/35R[EV]1899.4.19, 7:49 PM |
ACEC
