1Press and hold the clamp of the speakTo connect audio equipment with an optical digitaler
terminal on the rear of the unit.input terminal
You can record CD sound onto the connected digital
2Insert the end of the speaker cord into theequipment.
terminal.
Match the polarity (color) of the speaker ter? tominals:
? and á to á.Protective
plug
3Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
Before connecting
the other equipment,
remove the
Connecting Other Equipmentprotective plug from
the terminal.
You can connect both analog and digital equipment.
Y DO NOT connect any equipment while the powerAudio equipment
is on.with an optical digital
input
Y DO NOT plug in any equipment until allTo optical
connections are complete.digital input
To connect an analog component
Be sure that the plugs of the audio cords are color coded:Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
White plugs and jacks are for left audio signals, and red onesCD OPTICAL DIGITAL OUTPUT terminal.
for right audio signals.
NOW, you can plug in the unit and other
connected equipment FINALLY!
When connecting the AC power cord into a wall outlet, the
Audio/videounit automatically starts display demonstration.
equipment
To audio outputTo stop the display demonstr press anation,y button on the
unit or on the remote control.
For playing the other equipment through this unit,
connect between the audio output jacks on the otherTo start the display demonstration manually
equipment and AUX jacks by using audio cords (notPress and hold DEMO for more than 2
supplied).seconds.
To stop the demonstration, press any button.
� 8 �
EN01-14.MXJ500,etc[B]/f800.1.10, 2:08 PM |
ACEC
