3.3 DVD mechanism section
? Remove the top cover.
? Remove the front panel assembly.
? Remove the DVD mechanism assembly.
3.3.1 Removing the tray
(See Figs.1 and 2)
(1) From the left side of the DVD mechanism assembly, push
the slide cam in the direction of the arrow 1 and then pullTray
out the tray in the direction of the arrow 2. (See Fig.1.)
(2) Push the tray stoppers a in the direction of the arrow 3, pull
out the tray in the direction of the arrow 4. (See Fig.2.)
2
3.3.2 Attaching the tray
(See Fig.2)
When attaching the tray, insert the tray to the rail of the DVD1
Slide cam
mechanism assembly and then push the tray in the DVD mech-Fig.1
anism assembly.
Tray stoppers a
3
4
Tray
DVD mechanism assembly
Fig.2
3.3.3 Removing the tray
(See Fig.3)
(1) From the bottom side of the DVD mechanism assembly,
disconnect the card wires from the connectors CN201 andFlexible wire
CN202 on the DVD servo board.
Short land sections b
Caution:
Be sure to solder the short land sections b on the flexible
wire before disconnecting the flexible wire from connec-
tor CN101 on the DVD servo board.
If the flexible wire is disconnected without attaching sol-
DVD mechanism assembly
der, the DVD pickup unit may be destroyed by static
electricity.
(2) Release the locks of the connector CN101 on the DVD ser-
vo board in the direction of the arrow 1, disconnect the flex-Card wire
ible wire.
Card wire
Caution:
In the assembly, be sure to remove solders from theCN201
short land sections b after connecting the flexible wire toCN202
the connector CN101 on the DVD servo board.Claw c
(3) While pushing the claws c of the DVD mechanism assem-
bly in the direction of the arrow 2, remove the DVD servoClaw c
board in an upward direction.11
222
DVD servo board
CN101
Fig.3
(No.22023)1-15 |