Rear Panel
89 0!@ #$
AC 120V ~ 50 Hz/60 Hz
HD-INMONI21 OUTRS-232C
SDI
ASI OUTREF IN(D1)AES/EBU IN
8[AC IN] Power input terminal@[REF IN (D1)] External reference
Use the power cord supplied to connect to an ACsynchronized signal input terminal (BNC)
120 V 50 Hz/60 Hz outlet.Input external reference synchronized signal.
For reference synchronized signal, use the sig-
nal that is compliant to SMPTE259M (D1).
9[HD-SDI IN] Video signal input terminal (BNC)
Input terminal for HD serial digital video signal.
When using the external reference synchro-
This terminal also receives audio signal when
MemoMemonized signal input terminal, set the Sync Mode
audio signal is embedded into HD serial digital
item in the Configuration Menu to OREF�.
video signal.
Page 13 OConfiguration Menu�
Connect to the HD serial digital video signal out-
put terminal of the device outputting video signal.Y When using the external reference synchro-
CautionCautionsCautionssnized signal, keep the phase difference of ex-
0[HD-SDI MONI OUT] Video signal outputternal reference synchronized signal and input
video signal within ?5H (1H: D1signal cycle).
terminal (BNC)
(Phase zero is defined when the forth pin of D1
Output terminal for through HDTV serial digital
signal matches with first pin of input video signal.)
video signal.Y Input D1 signal before turning on the power of
For checking the video signal inputted into HD-this unit. The encoding may not start if D1 sig-
SDI IN video signal input terminal 9 on the rearnal is not input when the power of this unit is
panel.turned on.
The output signal of HD-SDI MONI.OUT termi-#[AES/EBU IN] Audio signal input terminal
MemoMemo
nal that has not gone through re-clock process(BNC)
cannot be used as a formal SMPTE292MInput terminal for digital audio signal. Connect to the
(1080i/720p) standard HDTV serial digitaldigital audio signal output terminal of the device out-
video signal.putting audio signal.
When using the audio signal input terminal,
MemoMemo
![ASI OUT] Video signal output terminal (BNC �2)set the audio input item in the Configuration
TS output terminal.Encodes and outputs theMenu to OAES/EBU�.
video signal inputted into HD-SDI IN video signal Page 13 OConfiguration Menu�
input terminal 9 and the audio signal inputted
into AES/EBU IN terminal #.$[RS-232C]Remote terminal (D-sub 9pin)
This terminal also outputs encoded audio signalBy connecting to the device for remote control, con-
trol of this unit can be performed externally.
when audio signal is embedded into HD serial
digital video signal.
Pin assignment of RS-232C remote terminal
The audio signal may mix with noise when this
Pin No. Signal nameContent
MemoMemo
unit is unable to synchronize with the con-
91N.C
nected device or when the input signal (exter-
5
2RxDReceived data
nal reference synchronized signal, HD-SDI sig-
1
nal or AES/EBU signal) is interrupted.3TxDTransmitted data
6
4N.C
5SGGround
6N.C
7N.C
8N.C
9N.C
Tranfer speed38.4 kbps
Data bit8 bit
Parity None
StopBit1 bit
Flow ControlNone
8
DM-JV600U.LST0159-001A803.11.7, 1:32 PM |
ACEC
