E6851BD_EN.book Page 4 Tuesday, August 2, 2005 5:57 PM
Connection to PowerMaintenance
Before you startBefore Switching on make sure that the voltage of CLEANING THE UNIT
your electricity supply is the same as that indicated on Use a soft cloth slightly moistened with a mild
the rating plate.detergent solution. Do not use solutions containing
alcohol, spirits, ammonia or abrasive.
Mains Cord
This appliance may be fitted with a non-rewireable CLEANING DISCS
plug. If it is necessary to change the fuse in a If a disc becomes dirty, clean it with a cleaning cloth.
nonrewireable plug the fuse cover must be refitted. If Wipe the disc from the centre out. Do not wipe in a
the fuse cover is lost or damaged, the plug must not circular motion.
be used until a replacement available from the Do not use solvents such as benzine, thinner,
appliance manufacturer is obtained.commercially available cleaners, detergent, abrasive
It is important that the colour of the replacement fuse cleaning agents or antistatic spray intended for
cover corresponds with the rating marking on the analogue records.
base of the plug.
If the plug has to be changed because it is not DISC HANDLING
suitable for your socket, or becomes damaged, it Handle the discs so that fingerprints and dust do not
should be cut off and an appropriate plug fitted adhere to the disc surfaces.
following the wiring instructions below. The plug Always store the disc in its protective case when it is
removed must be disposed of safely as insertion into not in use.
a 13A socket is likely to cause an electrical hazard.
For your own safety read the following instructions SERVICING
carefully before attempting to connect this unit to If the unit becomes inoperative, do not try to correct
mains.the problem by yourself. There are no user
The wires in this mains lead are coloured in serviceable parts inside. Turn the unit off, unplug the
accordance with the following code:mains cable, and consult your dealer or an authorized
service centre.
BLUE=NEUTRAL, BROWN=LIVE
CLEANING THE DISC LENS
ImportantIf the unit does not perform correctly even though you
As the colours of the wires in the mains lead of this have referred to ?Troubleshooting? and the relevant
appliance may not correspond with the coloured sections in the Instruction Manual, the laser optical
markings identifying the terminals in your plug, pickup unit may be dirty. Consult your dealer or an
proceed as follows:-authorized service centre for inspection and cleaning
The wire which is coloured blue must be connected to of the laser optical pickup unit.
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
No connection is to be made to the earth terminal of
the plug.
If a 13 Amp (BS 1363) Plug is used, a 3 Amp Fuse
must be fitted, or if any other type of Plug is used a 3
or 5 Amp Fuse must be fitted, either in the Plug or
Adaptor, or on the Distribution Board.
Mains Supply:220 - 240 V 50 Hz - AC only
Do not make any connection to the larger pin marked
with the letter ?E? or by the symbol or coloured
green or green and yellow.
FUSE
BROWN
(Live)
BLUE
(Neutral)
CORD GRIP
OUTER SHEATH OF THE WIRE
4EN |