TH-S33-11[C].book Page 34 Thursday, March 31, 2005 8:02 PM
References
To clean the disc
MaintenanceWipe the disc with a soft cloth in a straight
line from center to edge.
7 Handling DiscsEnglish DO NOT use any solvent ? such as
conventional record cleaner, spray,
? Remove the disc from its case by holding it thinner or benzine ? to clean the
at the edge while pressing the center hole
lightly.disc.
? Do not touch the shiny surface of the disc 7 Cleaning the system
or bend the disc.
? Put the disc back in its case after use to ? Stains on the system should be wiped off with a soft cloth. If the
system is heavily stained, wipe it with a cloth soaked in water
prevent warping.diluted neutral detergent and wrung well, then wipe clean with a
dry cloth.
? Be careful not to scratch the surface of the
disc when placing it back in its case. ? Since the system may deteriorate in quality, become damaged or
? Avoid exposure to direct sunlight, get its paint peeled off, be careful about the following.
?DO NOT wipe it with a hard cloth.
temperature extremes and moisture.
?DO NOT wipe it strong.
?DO NOT wipe it with thinner or benzine.
?DO NOT apply any volatile substance such as insecticides to it.
?DO NOT allow any rubber or plastic to remain in contact with
it for a long time.
Troubleshooting
PROBLEMPOSSIBLE CAUSESOLUTION
Power does not come The power cord is not connected.Connect the power cord correctly. (See page 9.)
on.
The remote control does The batteries are exhausted.Replace the batteries. (See page 6.)
not work.Sunlight is falling directly on the remote sensor.Hide the remote sensor from direct sunlight.
The remote control does The remote control mode is not for the desired source. Before operation, press one of the source selecting
not work as expected.buttons for the desired source.
No sound.The speaker cord is not connected.Check the connection. (See page 8.)
An incorrect source has been selected.Select the correct source. (See page 12.)
No picture is displayed The video cable is not connected correctly.Connect the cable correctly. (See page 9.)
on the TV screen.The disc is not playable.Use a playable disc. (See page 3.)
No picture is displayed The scan mode is set to ?PROGRESS? though the Change the scan mode to ?INTER,?. (See page 13.)
on the TV screen, the center unit is connected to the TV which does not
picture is blurred, or the support the progressive video input.
picture is divided into
two parts.
Video and audio are The disc is scratched or dirty.Replace or clean the disc.
distorted.
A VCR is connected between the center unit and the Connect the center unit and TV directly. (See page 9.)
TV.
The picture does not fit The monitor type is not set correctly.Set ?MONITOR TYPE? properly. (See page 30.)
the TV screen.
Hard to listen to Antennas are disconnected.Reconnect the antennas correctly and securely. (See
broadcast because of page 7.)
noise.
The system suddenly The playback level of the current source is too high.Play back the source with lower volume level.
turns off.
34 |
ACEC
