English
1If the cords are covered with insulation,Connecting Other Equipment
remove a short section of insulation at the
end of each cord by twisting and pulling itTo connect an audio equipment
off.You can connect audio equipmentNused only as a playback
device.
2Press and hold the clamp of the speaker
Y DO NOT connect any equipment while the power
terminal as illustrated.
is on.
Y DO NOT plug in any equipment until all
3Insert the end of the speaker cord into the
connections are complete.
terminal.
Match the polarity between the unit and the speakerBe sure that the plugs of the audio cords are colored: White
terminals: a to a and ? to ?.plugs and jacks are for left audio signals, and red ones for
right audio signals.
4Release your finger from the clamp.
RL
AUX
RY DO NOT connect speakers while the power is on.
Y DO NOT connect more than one speaker to each
speaker teminal.L
IMPORTANT: Use only speakers with the same speaker
To audio outputL
impedance as shown on the speaker terminals on theAudio equipment
Rrear of the unit.
For playing other equipment through this unit, connect
To remove the speaker grilles
The speaker grilles are removable.between the audio output jacks on the other equipment and
AUX jacks by using audio cords (not supplied).
Holes
Projections
Now, you are ready to plug in the unit
and any other connected equipment.
IMPORTANT: Be sure to check all connections to be
done before plugging the AC power cord into a wall outlet.
Speaker grille
To remove the speaker grille, insert your fingers at the top
of the speaker grille, pull towards you. Then pull the bottom
towards you.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
8
EN01-13_FS-J60&50[C]f.pm6803.1.23, 7:44 PM |
ACEC
